Modelling of Electric Power Subsystem for a Weather Balloon Microsatellite

Authors
  • W. O. Apena

    Department of Electrical and Electronic Engineering, The Federal University of Technology, Nigeria

  • K. F. Akingbade

    Department of Electrical and Electronic Engineering, The Federal University of Technology, Nigeria.

Keywords:
Balloon, Microsatellite, Photovoltaic, Radiation, Temperature
Abstract

This paper examines monocrystalline PV cell Electric Power Subsystem (EPS) for a Weather Balloon microsatellite. The study deplored initial knowledge on power system and energy conversion to simulate electric power subsystem model in MATLAB Simulink 2013b environment through mathematical equations. The research investigated atmospheric conditions with respect to P-V and I-V characteristics on photovoltaic cells initiatives. The study adopted characteristic effect of solar energy radiation from 1367W/m2 to 767W/m2 with respect to low orbit temperature. The study has shown that photovoltaic devices could be considered for generation of electric power energy for spacecraft and microsatellite stations due to its efficiency and ability for thermal cycles in lower orbit with respect to limited time varying degradation.

References
Cover Image
Downloads
Published
2019-05-04
Section
Articles
License

Copyright

With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.

How to Cite

Modelling of Electric Power Subsystem for a Weather Balloon Microsatellite. (2019). FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY, 11(1), 62-67. https://doi.org/10.51459/futajeet.2017.11.1.122

Similar Articles

31-31 of 31

You may also start an advanced similarity search for this article.