Investigation of Multilevel Transmission for SI-Plastic Optical Fibre (POF) Channel: PAM and OFDM
- Authors
-
-
W. O. Apena
-
I. Osahon
-
W. O. Popoola
-
- Keywords:
- Mutilevel, Transmission, Channel (POF), Bit Error Rate and Data Rate
- Abstract
-
This research studied the choice of Step-Index (SI)Plastic Optical Fibre (POF) as a vital channel for short distance Multilevel (PAM & OFDM) transmission scheme in optical communication system (OCS). This employed initial knowledge on digital modulation to select promised modulation techniques (QPSK-OFDM, 16QAM-OFDM, 2-PAM, and 4-PAM) for POF channel. The controlled experiment was setup in the laboratory using transmitter (LED-L10762, 70MHzand Bias T-ZFBT-4R2GW) and receiver (Photo-receiver) through POF channel length variation (45cm, 30m and 60m) to determine the frequency response (back-to-back) and data rate (DR) performance respectively. Itrevealed disparities in bit error rate (BER) and data rate (DR) performances with respect to distance variation (30m and 60m POF channel). In summary, the bit error rates (BERs) for 30m POF for the chosen modulation techniques are lower compared to 60m POF which shows significance of modulation techniques with respect to POF channel distance. The research shows that POF could be an effective channel for short distance network such as Local Area Network (LAN) and Campus Area Network (CAN) application.
- References
- Downloads
- Published
- 2019-11-17
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- O. S. Oyerinde, John A. V. Olumurewa, D. Fajobi, DRYING KINETICS OF FISH (Clarias gariepinus) SMOKED WITH BIOGAS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- W. A. Raheem, A. O. Ajayeoba, K. A. Adebiyi, O. R. Oyetunji, O. A. Ayeyemi, Ergonomic Evaluation of Base Transceiver Station Maintenance Personnel in Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- M. O. Oyeleye, Evaluation of Grid and Off-Grid Energy Consumption: A Case Study of Federal University of Technology, Akure (FUTA) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- M. K. Adeyeri, Assessment of Maintenance Activities of Some Sawmills in Ekiti and Osun States of Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- E. O. Ajaka, O. C. Chukwuma, Promax2100: A Computer Programme for Design and Optimization of Mineral Processing Plant , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- J. O. Amigun, Seismic Inverted Acoustic Impedance for Lithofacies Discrimination and Reservoir Fluids Prediction: A Case of ‘Ovi’ Field, Niger Delta , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- A. O. Melodi, B. O. Akinloye, Transmission Capacity Enhancement for Nigerian Power Transmission Grid using TCSC and UPFC , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 2 (2014): FUTA Journal of Engineering and Engineering Technology
- M. D. IDI, T. A. ALADESANMI, S. LUKMAN, M. A. ASANI, Y. M. USMAN, I. A. OKE, A NUMERICAL FORMULA AND COST BENEFIT OF GROUNDWATER RECHARGE IN MAIDUGURI, NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 2 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- P. M. Enyong, Performance of a Short Transmission Line Module under Various Loads: A Comparative Evaluation , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 2 (2018): FUTA Journal of Engineering and Engineering Technology
- B. O. Akinnuli, S. P Ayodeji, S. O. Abadariki, J. O. Fasan, Design, Fabrication and Performance Evaluation of a Reciprocating Cocoa Pod Breaking Machine , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.