Pyrolysis of Sugarcane Bagasse for Bio-Oil Production
- Authors
-
-
T. S. Mogaji
Department of Mechanical Engineering, School of Engineering and Engineering Technology, Federal University of Technology, P. M. B. 704, Akure, Ondo State, Nigeria
-
A. Akinsade
Department of Mechanical Engineering Federal University of Technology, Akure.
-
M. A. Akintunde
Department of Mechanical Engineering Federal University of Technology, Akure.
-
- Keywords:
- Bio-oil, biomass waste, sugarcane bagasse, pyrolysis, fixed bed reactor
- Abstract
-
One potential technique for alleviating environmental concerns from the release of green house gas (GHG) emission from fossil fuel burning is through conversion of biomass residue to other energy products such as bio-oil. This study focused on pyrolysis of sugarcane bagasse for bio-oil production.The pyrolysis of Sugarcane barggase (SB) as waste from raw sugarcane was carried out in a 35.3 litres capacity fixed bed reactor. The fixed bed reactor has overall dimensions of (238 mm diameter., 794 mm height) with handling capacity of 3 kg of feedstock per batch. The raw sugarcane collected from a local farm in Idanre metropolis was crushed, squeezed to extract the juice and sundried to lessen the moisture content. The dried sample of size < 1 mm was fed into the reactor at room temperature of 25oC and heated to a temperature of 500oC. The product of bio-oil was collected and assayed for their compositions, contents and characteristics. The chemical properties of the produced bio-oil were compared with literature values of bio-oil derived from other biomass wastes. The pyrolytic oils from the SB wastes are characterized by heating value (HV) of 17.33 MJkg-1, negligible amount of Sulphur and Nitrogen (0.88 and 0.01 % wt respectively) which resulted in lower emission of SO2 and NO2 consequently slighter environmental impact. The finding indicates that the pyrolytic oil from SB would be a suitable candidate for alternative energy fuels for combustion in a boiler or a furnace without any further chemical treatment. The study revealed that the bio-oil obtained from sugarcane bagasse is combustible and more environmentally friendly.
- References
- Downloads
- Published
- 2019-11-17
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- S. S. Yaru, I. K. Adegun, Analyses of Biogas and Digestate from Cattle Dung Anaerobic Digestion , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
- S. S. Yaru, I. K. Adegun, M. A. Akintunde, Comparative Study on Ignition Time of Biogas from Cattle Dung and Mixtures of Cattle Dung with Cassava Peels , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 1 (2015): FUTA Journal of Engineering and Engineering Technology
- M. A. Tijani, W. O. Ajagbe, O. A. Agbede, Modelling the Effect of Burning Temperature and Time on Chemical Composition of Sorghum Husk Ash for Optimum Pozzolanic Activity , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 2 (2018): FUTA Journal of Engineering and Engineering Technology
- J. O. BABAJIDE, E. O. FEHINTOLA, T. A. ALADESANMI, M. D. IDI, E. A. ADEKUNBI, I. A. OKE, E. O. OBIJOLE, NEWTON RAPHSON SOLUTIONS OF BIOCHEMICAL OXYGEN DEMAND (BOD) KINETICS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- Ayoola Jongbo, Adekunle T. Atta, Ian Moorcroft, EVALUATION OF THE INDOOR AIR VELOCITY OF A SIDEWALL INLET AND ROOF EXHAUST VENTILATED BROILER SHED USING COMPUTATIONAL FLUID DYNAMICS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- Obinna Obiora-Okeke, J. R. Adewumi, O. M. Ojo, IMPACT OF LAND USE AND LAND COVER CHANGES ON RUNOFF PREDICTION IN OGBESE RIVER WATERSHED , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- Folasade Dahunsi, Oluwasina Aderinwale, Abayomi Adesida, Abiola Alayande, J. Ojo, Oluwaseyi Falola, Oluwarotimi Dahunsi, DEVELOPMENT OF A SPACE TECHNOLOGY CAPACITY BUILDING INITIATIVE AT THE FEDERAL UNIVERSITY OF TECHNOLOGY, AKURE, NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- T E Abioye, DEVELOPMENT OF A POULTRY DE-FEATHERING MACHINE WITH AN ADJUSTABLE BASIN , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- A. S. Ojo, M. O. Alatise, Spatial Variability of Soil Physical Properties of a Typical Fadama Farmland (Ayede Ogbese) in South Western, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- J. A. Afelumo, O. A. Ademeso, Investigation of the Integrity of Subsoil as Foundation Support for a new Hostel Building, FUT, Akure, Southwestern Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.