THE PERFORMANCE OF DVB-T2 SIGNAL NETWORK IN THE DRY SEASON
A Case Study of Jos in Nigeria
- Authors
-
-
E.E. Igbonoba
Computer Engineering Department, University of Benin, Benin City, Nigeria.
-
A. I Edeoghon
Computer Engineering Department, University of Benin, Benin City, Nigeria
-
- Keywords:
- Propagation of DVB-T2 Signal, Field Measurement of Signal Parameters, Carrier to Noise Ratio (CNR) and Signal to Noise Ratio (SNR)
- Abstract
-
This study presents the performance of DVB-T2 Television network in Jos using Integrated Television Services Limited signal (NTA Signal Distribution Company). The perturbation arising from poor weather conditions remain a major problem to TV signal transmission in Nigeria due to signal attenuation and degradation between the transmitter and receiver station. These atmospheric perturbations are prevalent along the signal paths. This research aim is to evaluate the performance of DVB-T2 TV network in Jos, Plateau State. Drive test measurements methodology was adopted in measuring field strength and received signal strength parameters. These measured parameters were used to calculate for CNR and SNR through empirical method. Finally, CNR and SNR were used to evaluate the performance of DVB-T2 television network in Jos. The result of the research shows that DVB-T2 television network had a better signal quality (performance and coverage) in the dry season compared to the raining season.
- References
-
Akinbolati, A. Ajewole, M.O. Adedeji, A.T and Ojo, J.S. (2020): Propagation Curves and Coverage Area of Digital Terrestrial Television Base Station in the Tropical Zone. Heliyon 6, e 03599 (www.cell.com/heliyon)
Akinbolati, A. Akinsanmi, O. and Ekundayo, K.R. (2016): Signal Strength Variation and Propagation Profiles of UHF Radio Wave Channel in Ondo State, Nigeria. International Journal of Wireless Microwave Technology (UWMT) 6(4), 12-27
Armoogum, V. Soyjaudah, K. M. S. Mohamudally, N.and Forgarty, T. (2010): Propagation Models and Their Applications in Digital Television Broadcast Network Design and Implementation. In:Bouras, Christos J. (Ed), Trends in Telecommunications Technology, pp.165 – 183
Berjon-Eriz, G. Eizmendi, I. Vélez, M. Prieto, G. Montalban, J. Arrinda, A., and De la Vega,D. (2011): Performance Evaluation Procedure for Mobile DVB-T2 Reception in Urban Environments. Journal of Department of Electronics and Telecommunications Engineering, University of the Basque Country, Spain, BMSB 2011 mm 11-89. (gorka.berjon@ehu.es)
B. Series. (2012): Frequency and Network Planning Aspects of DVB-T2.
Cetin, K. and Begum, K.E. (2016): Measurement and Evaluation of Electric Field Strength in Samsun Centre. International Journal of Applied Mathematics, Electronics and Computers, ISSN: 2147-8228, 3 September 2016. (http://ijamec.atscience.org)
ETSI EN 300 744. (2009): Digital Video Broadcasting (DVB); Framing Structure, Channel Coding and Modulation for Digital Terrestrial Television (DVB-T). ETSI EN 300 744 Vol.1.6.1, January 2009.
ETSI EN 302 307. (2009): Digital video broadcasting: second generation framing structure,
Coding and Modulation Systems for Broadcasting, Interactive Services, News Gathering
and other Broadband Satellite Applications. ETSI EN 302 307, Vol.1.2.1, August 2009.
ETSI EN 302 755. (2011): Digital Video Broadcasting (DVB); Frame structure channel
Coding and Modulation for a Second Generation Digital Terrestrial Television
Broadcasting System (DVB- T2)â€, ETSI EN 302 755 Vol.1.2.1, February 2011.
Faruk, N. Ayeni, A. A. and Adediran, A. Y. (2013): On the Study of Empirical Path-loss Model for Accurate Prediction of TV Signal for Secondary Users. Programme Electromagnetic Resources, B 49 (1-5)
IEEE 802.22. (2011): Standard for Wireless Regional Network – Part 22: Cognitive Wireless RAN Medium Access Control (MAC) and Physical Layer (PHY) Specifications: Policies and Procedures for Operation in the TV Bands.
ITU-R. (2016): DTTB Handbook: Digital Terrestrial Television Broadcasting Networks and Systems Implementation. Geneva 28 October, 2016.
ITU-R. (2011): Methods for measurements on digital broadcasting signals. Recommendation
ITU-R SM.1682-1, September, 2011
Kondrad, L. Bouazizi, I. Vadakital, V. K. Hannuksela, M. M and Gabbouj, M. (2009): Cross-Layer Optimized Transmission of H.264/SVC Streams over DVB-T2 Broadcast System. IEEE International Symposium on Broadband Multimedia Systems and Broadcasting 2009, BMSB'09. pp. 1-5.
Lusekelo, K. and Anael, S. (2014) Performance Evaluation of Dvb-T2 Network and Its Optimization Recommendations a Case of Dar Es Salaam, Tanzania. International Journal of Advanced Research in Computer Science and Software Engineering, ISSN: 2277 128X. Volume 4, 4, April 2014. (www.ijarcsse.com)
Nadir, Z. Elfadhil, N. and Touati, F. (2008): Path-loss Determination Using Okumura-Hata
Model and Spline Interpolation for Missing Data for Oman. Proceedings of the World
Congress on Engineering 2008, Vol. 1, WCE 2008, July 2 – 4, London, U.K.
Shalangwa, D. (2010): Path-loss Propagation Model for Gombi Town, Adamawa State
Nigeria. International Journal of Computer Science and Network Security. (www.semanticscholar.org)
World Mobile Congress. (2014): Wireless Communication Design and Test Solutions.
(www.wireless.agilent.com)
- Downloads
- Published
- 2021-11-30
- Section
- Articles
- License
-
Copyright (c) 2021 FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- B. V. Omidiji, H. A. Owolabi, T. A. Morakinyo, A. Olukoga, Effects of Machining Parameters on the Surface Roughness of Al-Si alloy , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 2 (2015): FUTA Journal of Engineering and Engineering Technology
- Olanrewaju Oluwafemi Akinfala, Emmanuel Enyeribe Ege, Ladi Folorunso Ogunwolu, ARRIVAL PATTERNS AND TRAFFIC FLOW CHARACTERISTICS AT SIGNALIZED INTERSECTIONS: CONSIDERING UPSTREAM SIGNAL INFLUENCE AND TIME RESOLUTIONS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- Y. O. Olasoji, S. A. Oyetunji, Propagation Path Loss Model for FM Radio Stations In South West, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- O. O. Olubanjo, Assessment of Groundwater Quality For Human Consumption And Agricultural Use In Ilara-Mokin, Ondo State, Nigeria. , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 2 (2016): FUTA Journal of Engineering and Engineering Technology
- E. I. Bello, I. A. Daniyan, T. I Ogedengbe, L. Lajide, P. B. Mogaji, Development of a Model for Predicting the Yield of Biodiesel During Biodiesel Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- I. A. Daniyan, E. I. Bello, T. I. Ogedengbe, L. Lajide, P. B. Mogaji, Development of a Model For Predicting the Yield of Biodiesel During Biodiesel Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 1 (2016): FUTA Journal of Engineering and Engineering Technology
- K. O. Oladosu, E. O. Olafimihan, K. A. Babatunde, B. Kareem, A. A. Mustapha, Investigation of Staged Air supply on Grate Combustion of Palm Kernel Shell Mixed with Selected additives (Al2O3 and CaO) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- Olufemi Adeyemi Adetola, M. J. Odu, THE DEVELOPMENT OF A HAND-PUSH WEEDER FOR CUTTING WEEDS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- P. B. Mogaji, T. E. Abioye, N. O. Ohuruogu, Development of Epoxy Resin Composite Reinforced With Cow Horn and Cassava Particles for Car Dashboard , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- S. S. Yaru, POLLUTION OF VEHICULAR EMISSION ANALYSIS AT FEDERAL UNIVERSITY OF TECHNOLOGY AKURE NORTH GATE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.
