DETERMINATION OF THE PHYSICOCHEMICAL PROPERTIES OF WASTEWATER OBTAINED FROM A SOAP-MAKING INDUSTRY
- Authors
-
-
Adedamola Oluwafemi Ojo
Yaba College of Technology, Yaba, Lagos, Nigeria
-
Kayode Hassan Lasisi
Federal University of Technology, Akure, PMB 704, Nigeria
-
Fidelis Odedishemi Ajibade
Federal University of Technology, Akure, PMB 704, Nigeria
-
Temitope Fausat Ajibade
Federal University of Technology, Akure, PMB 704, Nigeria
-
Ndeze C. K
University Awka, Anambra State
-
- Keywords:
- Physicochemical properties, Industrial pollution, Wastewater, Heavy metals
- Abstract
-
Water contamination, particularly of surface water, is predominantly attributed to anthropogenic activities, notably the indiscriminate discharge of effluents (comprising both industrial and domestic wastes) into local drainage systems, which ultimately convey these pollutants into natural water bodies. This study aims to assess the physicochemical characteristics of wastewater sourced from a soap-manufacturing industry. Parameters such as pH, temperature, electrical conductivity, total solids (TS), and dissolved oxygen (DO) were analyzed using a Hanna multi-parameter probe (HI 9813-6 pH/EC/TDS/°C Meter). Additionally, Biological Oxygen Demand (BOD), Chemical Oxygen Demand (COD), oil/grease content, and heavy metal concentrations were determined in accordance with standard analytical procedures. Three effluent samples, collected from designated point-source discharges within the industrial facility, were examined. The zinc concentrations (15.13 mg/L (A), 12.21 mg/L (B), 5.88 mg/L (C) ) for the effluent samples were found to exceed the permissible limits established by the Federal Environmental Protection Agency (FEPA). Furthermore, Samples A and B exhibited critically elevated COD levels ( 97, 92) respectively, which are deemed highly non-compliant with FEPA guidelines. The findings of this study underscore the urgent necessity for the treatment of industrial effluents prior to their release into the environment.
- Author Biographies
- References
-
Adewumi, J. R. and Ajibade, F. O. (2019). Periodic Determination of Physicochemical and Bacteriological Characteristics of Wastewater Effluents for Possible Reuse as Irrigation Water. International Journal of Energy and Water Resources, 3(4), 269 – 276. https://doi.org/10.1007/s42108-019-00036-6
Ajala, O. A., Oke, M.R., Ajibade, T.F., Ajibade, F.O., Adelodun, B., Ighalo, J.O., Ajala, M.O., Kumar, P., Demissie, H., Ugya, A.Y., Sulaymon, I.D., and Silva, L.F.O. 2022. Concentrations, bioaccumulation, and health risk assessments of heavy metals in fishes from Nigeria’s freshwater: A general overview. Environmental Science and Pollution Research 29, 82660–82680. https://doi.org/10.1007/s11356-022-23390-1
Ajibade, F.O., Adelodun, B., Lasisi, K.H., Fadare, O.O., Ajibade, T.F., Nwogwu, N.A., Sulaymon, I.D., Ugya, A.Y., Wang, H.C., and Wang, A. (2021a). Environmental Pollution and their Socio-economic Impacts. In: Kumar, A., Singh, V. K., Singh, P. K., and Mishra, V. (eds) Microbe mediated Remediation of environmental contaminants, Woodhead Publishing, Elsevier, US. https://doi.org/10.1016/B978-0-12-821199-1.00025-0
Ajibade, F.O., Nwogwu, N. A., Lasisi, K.H., Ajibade, T.F., Adelodun, B., Guadie, A., Ugya, A.Y., Adewumi, J. R., Wang, H.C., and Wang, A. (2021b). Removal of Nitrogen Oxyanion (Nitrate) in Con-structed Wetlands. In: Oladoja, N. A., and Unuabonah, I.E. (eds). Progress and Prospects in the Man-agement of Oxoanion Polluted Aqua Systems, Springer Nature, The Netherlands, Springer Nature, Netherlands. https://doi.org/10.1007/978-3-030-70757-6
Ajibade, F. O., Wang, H., Guadie, A. A., Ajibade, T. F., Fang, Y., Sharif, H. M. A., Liu, W., and Wang, A. (2021c). Total nitrogen removal in biochar amended non-aerated vertical flow constructed wetlands for secondary wastewater effluent with low C/N ratio: Microbial community structure and dissolved organic carbon release conditions. Bioresource Technology, 322, 124430. https://doi.org/10.1016/j.biortech.2020.124430
Ajibade, F.O., Adelodun, B., Ajibade, T. F., Lasisi, K. H., Abiola, C., Adewumi, J. R. and Akinbile, C.O. (2021d). The Threatening Effects of Open Dumping on Soil at Waste Disposal Sites of Akure City, Nigeria. International Journal of Environment and Waste Management, 27(2): 127 - 146. https://doi.org/10.1504/IJEWM.2021.10030610.
Alaneme, G. U., Attah, I. C., Fadugba O. G., Olaiya, B. C., and Ajibade, F. O. (2024). Comparative study of industrial effluents for biorefinery conversion. In: Naushad, M., Hossain, M. S., Jagaba, A. H., Kutty, S. R. M., Birniwa, A. H. (eds). Biorefinery of Industrial Effluents for a Sustainable Circular Economy, 357-372. https://doi.org/10.1016/B978-0-443-21801-9.00025-2
Anjali Acharya, Vasudha Ashutosh Gokhale , Deepa Joshi (2014). Impact of Biomedical Waste on City Environment: Case Study of Pune, India. IOSR Journal of Applied Chemistry (IOSR-JAC),Volume 6, Issue 6 (Jan. 2014), PP 21-27
Ilori, B. A., Adewumi, J. R., Lasisi, K. H., and Ajibade, F. O. (2019). Qualitative Assessment of Some Available Water Resources in Efon-Alaaye, Nigeria. Journal of Applied Science and Environmental Management (JASEM), 23(1), 29 – 34. Doi: 0.4314/jasem.v23i1.5
Rajaram, T. and Ashutost, D., 2008. Water pollution by industrial effluents in India: discharge scenario and case for participatory ecosystem specific local regulation. Environmental Journal, 40(1), pp.56–69.
Raji, M.I.O., Ibrahim, Y.K.E., Tytler, B.A. and Ehinmidu, J.O., 2015. Physicochemical characteristics of water samples collected from River Sokoto, Northwestern Nigeria. Atmospheric and Climate Sciences, 5(3), pp.194.
Rotimi, I.M., Adewumi, J.R., Ajibade, F.O. (2021). Treatment of Rubber Latex Processing Wastewater Using Activated Carbon Derived from Palm Kernel Shell. Nigerian Research Journal of Engineering and Environmental Sciences, 6(2), 741-752.
Zabbey, N., Kpaniku, N.C., Sam, K., Nwipie, G.N., Okoro, O.E., Zabbey, F.G., and Babatunde, B.B. (2021). Could community science drive environmental management in Nigeria's degrading coastal Niger delta? Prospects and challenges. Environmental Development, 37, 100571. https://doi.org/10.1016/j.envdev.2020.100571
- Downloads
- Published
- 2025-05-30
- Section
- Articles
- License
-
Copyright (c) 2025 FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- I. O. Oladele, O. O. Daramola, A. Oyetunji, Appropriate Technological Procedures for Fusion Welding of Low Alloy Carbon Steel , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- Olabinjo, O. O., , Olusola, G. T. , Sama, M. O., EVALUATION OF PHYSICAL, CHEMICAL AND MICROBIAL PROPERTIES OF DATE FRUIT SEEDS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 1 (2024): FUTA Journal of Engineering and Engineering Technology
- M. M. Melodi, O. S. Adekinya, Assessment of Cost Effectiveness of Borehole Drilling in Oyo State, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 1 (2016): FUTA Journal of Engineering and Engineering Technology
- F. O. Ajibade, J. R. Adewumi, Performance Evaluation of Aquatic Macrophytes in a Constructed Wetland for Municipal Wastewater Treatment , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- S. S. Yaru, POLLUTION OF VEHICULAR EMISSION ANALYSIS AT FEDERAL UNIVERSITY OF TECHNOLOGY AKURE NORTH GATE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- I O OLADELE, O O DARAMOLA, A M OKORO, J A OMOTOYINBO, EVALUATION OF THE EFFECT OF MERCERIZED WHITE CHICKEN FEATHER FIBRES ON THE MECHANICAL , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- A. P. Olalusi, Comparison of Selected Engineering Properties of Two Species of Cocoyam Essential for Handling of the Tubers , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 2 (2014): FUTA Journal of Engineering and Engineering Technology
- I. O. Oladele, O. G. Agbabiaka, A. S. Ogunbadejo, M. A. Okoro, Assessment of Mechanical Properties of Hybrid Composites Based on Polypropylene and Vegetable Fibers , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 2 (2015): FUTA Journal of Engineering and Engineering Technology
- E. O. Ajaka, O. C. Chukwuma, Promax2100: A Computer Programme for Design and Optimization of Mineral Processing Plant , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- D. T. Oloruntoba, S. O. Seidu, Effect of Mill Scale Particulate in Sand Mould on the Microstructure and Mechanical Properties of Cast 6063 Aluminium Alloys , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 2 (2014): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.
