ASSESSMENT OF ELECTROMAGNETIC WAVES EMISSION IN SELECTED BUILDINGS AT THE FEDERAL UNIVERSITY OF TECHNOLOGY, AKURE: IMPLICATIONS FOR OCCUPATIONAL HEALTH AND RADIO FREQUENCY EXPOSURE
- Authors
-
-
C. N. Udekwe
Department of Information and Communication Engineering, Federal University of Technology, Akure, Ondo State, Nigeria
-
A. O. Dahunsi
Department of Computer Engineering, Federal University of Technology, Akure, Ondo State, Nigeria
-
A. A. Ponnle
Department of Electrical and Electronics Engineering, Federal University of Technology, Akure, Ondo State, Nigeria
-
F. M. Dahunsi
Department of Computer Engineering, Federal University of Technology, Akure, Ondo State, Nigeria
-
K. B. Adedeji
Department of Electrical and Electronics Engineering, Federal University of Technology, Akure, Ondo State, Nigeria
-
- Keywords:
- Electromagnetic Field, Radio-frequency, Trifield TF2 Meter, Contour Distribution, Academic Building
- Abstract
-
This study presents a spatial assessment of electromagnetic field (EMF) and radio frequency (RF) emissions in three faculty buildings which are SEMS, Old SET, and New SET, at the Federal University of Technology, Akure (FUTA), Nigeria. The research aims to quantify indoor EMF exposure levels and assess their implications for occupational health and radio frequency safety. Using a TriField TF2 meter, over 90 measurement points were surveyed across multiple floors under both load and no-load conditions. Electric field strengths were recorded up to 400?V/m (standard) and 350?V/m (weighted), while magnetic fields peaked at 0.9?mG (standard) and 0.8?mG (weighted). RF power densities ranged from 0.9?mW/m² to a maximum of 1.8?mW/m². Spatial variations revealed that hotspots occurred near sockets, routers, and electronic clusters, particularly in high-occupancy zones and along building perimeters. Contour plots generated via MATLAB provided visual insights into field propagation, identifying elevated exposures in biologically sensitive weighted readings, which were often underestimated by standard measurements. Although most values remained within ICNIRP and WHO exposure limits, several zones indicated potential long-term exposure risks. Consequently, strategic recommendations were proposed, including the repositioning of wireless access points, establishment of low-EMF zones, proper cable shielding, device usage awareness, and routine EMF audits. These findings underscore the need for proactive EMF management in academic environments to ensure safe learning and working conditions, and they establish a framework for future longitudinal monitoring of EMF exposure on university campuses.
- References
-
Bromeka. (2009). Scientific Committee on Emerging and Newly Identified Health Risks SCENIHR.
Huang, W., Hu, Y., Zhu, J., Cen, Z., and Bao, J. (2022). The Measurement and Evaluation of the Electromagnetic Environment from 5G Base Station. Detection, 09(01), 1–11.
Isabel Lopez, Marco Rivera, Nazario Felix, and Ceferino Maestu. (2022). It is mandatory to review environmental radiofrequency electromagnetic field measurement protocols and exposure regulations: An opinion article. Frontiers In Public Health, 1–5.
Jangid, P., Rai, U., Sharma, R. S., and Singh, R. (2023). The role of non-ionizing electromagnetic radiation on female fertility: A review. International Journal of Environmental Health Research, 33(4), 358–373.
Marino, C., Croft, R., Hirata, A., D’inzeo, G., Oftedal, G., Röösli, M., Rongen, E. van, Watanabe, S., Karipidis, K., Huss, A., Cridland, N., and Miller, S. (2025). Gaps in Knowledge Relevant to the “ICNIRP Guidelines for Limiting Exposure to Time-Varying Electric, Magnetic and Electromagnetic Fields (100 kHz TO 300 GHz).” Health Physics, 128(2), 190–202.
NCI. (2025). Electromagnetic Fields and Cancer. National Cancer Institute.
Ochu. A.Y, Sabo. A, and Garba. T. (2022). Assessment of Indoor Non-ionising Radiation of Selected Residential Apartments in Gombe Metropolis, Gombe State, Nigeria. Bima Journal of Science and Technology, 6(03), 232–238.
Samaila. B, Abdullahi A.H, Yahaya M.N, and Abubakar N. (2023). Residential Exposure to Non-ionizing Electromagnetic Radiation from Mobile Base Stations: A Systematic Review on Biological Effects Assessment. Material Science and Engineering International Journal, 7(2), 44–52.
Sanusi Kazaure, J., and Okwudili Matthew, U. (2021). Electromagnetic Radiation (EMR) and Human Health: A Study on the Health Effect of EMR from GSM Base Stations in North-Western Nigeria. American Journal of Electrical and Computer Engineering, 5(1), 14.
Siegel, R. L., Miller, K. D., Fuchs, H. E., and Jemal, A. (2022). Cancer statistics, 2022. CA: A Cancer Journal for Clinicians, 72(1), 7–33.
Smith-Roe, S. L., Wyde, M. E., Stout, M. D., Winters, J. W., Hobbs, C. A., Shepard, K. G., Green, A. S., Kissling, G. E., Shockley, K. R., Tice, R. R., Bucher, J. R., and Witt, K. L. (2020). Evaluation of the genotoxicity of cell phone radiofrequency radiation in male and female rats and mice following subchronic exposure. Environmental and Molecular Mutagenesis, 61(2), 276–290.
Trifield TF2 Meter. (2018). TRIFIELD TF2 OWNER’S MANUAL Pdf Download | ManualsLib.
Verbeek, J., Zeeb, H., van Deventer, E., Ijaz, S., Doré, J. F., Driessen, S., Roth, N., and Whaley, P. (2025). Systematic reviews and meta-analyses for the WHO assessment of health effects of exposure to radiofrequency electromagnetic fields, an introduction. In Environment International (Vol. 203). Elsevier Ltd.
- Downloads
- Published
- 2026-03-13
- Section
- Articles
- License
-
Copyright (c) 2026 FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- Olanrewaju Oluwafemi Akinfala, Emmanuel Enyeribe Ege, Ladi Folorunso Ogunwolu, ARRIVAL PATTERNS AND TRAFFIC FLOW CHARACTERISTICS AT SIGNALIZED INTERSECTIONS: CONSIDERING UPSTREAM SIGNAL INFLUENCE AND TIME RESOLUTIONS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- Samuel L Akingbonmire, L Samuel, O Oluwafemi Omotayo, J O Afolayan, A Banjo Olorunshola, THE PHYSICO-CHEMICAL PROPERTIES OF SOME FINE AGGREGATES IN LOKOJA, NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 2 (2018): FUTA Journal of Engineering and Engineering Technology
- W. O. Apena, I. Osahon, W. O. Popoola, Investigation of Multilevel Transmission for SI-Plastic Optical Fibre (POF) Channel: PAM and OFDM , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- Obinna Obiora-Okeke, J. R. Adewumi, O. M. Ojo, IMPACT OF LAND USE AND LAND COVER CHANGES ON RUNOFF PREDICTION IN OGBESE RIVER WATERSHED , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- P. B. Mogaji, O. A. Raimi, Determination of Optimum Parameters for Drilling Stainless Steel using Response Surface Methodology (RSM) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 1 (2016): FUTA Journal of Engineering and Engineering Technology
- B. V. Omidiji, H. A. Owolabi, T. A. Morakinyo, A. Olukoga, Effects of Machining Parameters on the Surface Roughness of Al-Si alloy , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 2 (2015): FUTA Journal of Engineering and Engineering Technology
- Emem Ayankop Andi , Ja’afaru Yahaya Bawa, Emem A. A, ’afaru Y. B, EFFECT OF DRILLING PARAMETERS ON DRILLING PERFORMANCE FACTORS IN HORIZONTAL WELLS USING SIMULATION APPROACH. , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 2 (2024): FUTA Journal of Engineering and Engineering Technology
- S. P. Ayodeji, M. K. Adeyeri, O. O. Oni, Conceptual Design of Battery Powered Vehicle for Children Amusement Park Using Nigerian Anthropometric Parameters , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
- Oluwole Timothy Ojo, FINITE ELEMENT ANALYSIS OF REDESIGNED PIPE-WRENCH FOR OILFIELD SERVICING , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- T A EWEMOJE, S D FAGBAYIDE, K O OLUWASEMIRE, LYSIMETER DETERMINATION OF CROP COEFFICIENT OF DRIP IRRIGATED JATROPHA CURCAS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.
