IMPROVING THE EFFICIENCY OF TITANIUM DIOXIDE BASED DYE SENSITIZED SOLAR CELL (DSSC) USING SILVER SURFACE COUNTER ELECTRODE
- Authors
-
-
Charity Segun Odeyemi
Department of Electrical Electronics Engineering, Federal University of Technology, Akure, Ondo State
-
Ayodeji Oladiran Awodugba
Department of Pure and Applied Physics, Ladoke Akintola University of Technology, Ogbomoso
-
- Keywords:
- Sensitized, electrode, Counter electrode, Titanium dioxide, efficiency
- Abstract
-
The high cost of processing crystalline silicon for solar cell has shifted research focus to cheaper materials for solar cell production. Although a variety of advanced approaches to solar cell are being investigated, dye sensitized solar cell (DSSC) is expected to offer one of the lowest manufacturing costs in the future because of its simplicity and use of cheap materials. However, the major challenge being faced in DSSC technology is its low efficiency. In an effort to improve the performance of DSSC, this work focused on the use of a silver surface glass for the counter electrode instead of the transparent glass which is normally used. Two solar cells were produced based on Gratzel method. In the first one, both the working electrode and the counter electrode were made of transparent conductive glass substrate. In the second cell, the titanium dioxide was coated on a transparent conductive glass electrode substrate to form the working electrode while a silver surface glass was used for the counter electrode. Teak extract was used as the organic dye sensitizer and potassium iodate as the electrolyte. The solar cell was then illuminated and tested. The results of the performance evaluations carried out show that the cell with silver surface counter electrode has an improved efficiency of about 400%. The result of the study therefore shows that the conductivity of the counter electrode material has effect on the performance of DSSC.
- References
-
Awodugba A. O. and Olabisi I. A. (2013): Fabrication of Dye Sensitized Solar Cell (DSSC) using ZnO Nanoparticles Synthesized from Zinc Nitrate Hexahydrate. Canadian Journal of Pure and Applied Sciences, Academic Publishers, British Columbia (7) 3 2635-2638
Lung-Chien C, Chih-Hung H, Po-Shun C, Xiuyu Z and Cing-Jhih H. (2014). Improving the performance of dye-sensitized solar cells with TiO2/graphene/TiO2 sandwich structure. Nanoscale Research Letters (1) 9,380.
Luttrell T, Sandamali H, Junguang T, Alan K, Eli S. & Matthias B. (2014) Review of Solar cell materials, Nature Scientific Journal (4) 3, 4043.
Mehmood U, Rahman S, Harrabi K, Hussein I. A., and Reddy B. V. S. (2014), Advances in Dye Sensitized Solar Cells. Advances in Materials Science and Engineering, (3) 7, 204
Moe M. A., Than T. W, Yin M. M, and Ko K. K. S. (2014): Binary Oxide Photoelectrode with coffee natural Dye Extract for DSSC Application. International Journal of Innovation and Scientific Reseach (8) 2, 276-282.
Pablo D, Stefan G, Tomas L, Nakita K. N, Ullrich S, and Henry J. S. (2014). From Dye-Sensitized Solar Cells to All-Solid-State Hybrid Devices. Material Review (3) 2, 45-50.
Shitta, M. B. O., Odeyemi, C. S., and Adetuyi A. O. (2008): The Photovoltaic Properties of some African Dyes, Material Science Research. (5) 2, 277-282.
Simon M. (2014): Dye Sensitized Solar Cells with 13% efficiency through the molecular Engineering of Porphyrin Sensitizers. Nature Chemistry (6), 242-247.
Christies, R. M. (2001): Colour chemistry, Royal Society of Chemistry, UK . Ch 4. 172-175.
Reeds, R. B. (1991): Systematic Mineralogy, Macmillan Publisher Limited UK. Ch 8 272-273.
White R. M. (1992): Solar Cell – From Basics to Advance System. McGraw-Hill, USA. Ch 12, 74-78.
Eddy Current Technology Inc. ECT (2014); Electrical Conductivity http://www.eddy-current.com.
Institute of Chemical Education ICE (2007): Recreating Photosynthesis, Nanocrystalline Solar Cell Manual. Department of Chemistry University of winsconsin- Madison.
US Energy Information Administration EIA (2016): International Energy Outlook. US Department of Energy, Washington DC, USA.
- Downloads
- Published
- 2019-04-29
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- K. O. Oladosu, E. O. Olafimihan, K. A. Babatunde, B. Kareem, A. A. Mustapha, Investigation of Staged Air supply on Grate Combustion of Palm Kernel Shell Mixed with Selected additives (Al2O3 and CaO) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- O. O. Awopetu, Cyclical Chips Formation during Machining of Titanium and Titanium Alloys , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 1 (2016): FUTA Journal of Engineering and Engineering Technology
- A. M. Akintade, O. J. Olukunle, J. Isa, Performance Evaluation of an Electromechanical Groundnut Roasting Machine Akintade A.M, Olukunle O. J. and Isa J. , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 2 (2014): FUTA Journal of Engineering and Engineering Technology
- T E Abioye, DEVELOPMENT OF A POULTRY DE-FEATHERING MACHINE WITH AN ADJUSTABLE BASIN , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- O. O. Awopetu, Effect of Rake Face Reinforcement on Cutting Tool Life of Cemented Carbide Tools during Turning of a-Titanium Alloy , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- B. O. Akinnuli, S. P Ayodeji, S. O. Abadariki, J. O. Fasan, Design, Fabrication and Performance Evaluation of a Reciprocating Cocoa Pod Breaking Machine , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- F. O. Ajibade, J. R. Adewumi, Performance Evaluation of Aquatic Macrophytes in a Constructed Wetland for Municipal Wastewater Treatment , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- J.A. Ojumu,, EFFECT OF SYNTHESIZED SILVER NANOPARTICLES FROM ALOE VERA PLANT LEAF EXTRACT ON CORROSION BEHAVIOUR OF API 5L IN 0.5M OF H2SO4 , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- H. A. Owolabi, B. V. Omidiji, A. O. Oke, A. T. Morakinyo, Development of a Small-Scale Motorized Dough Kneading Machine , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
- J. O. Ojediran, J. T. Fasinmirin, O. P. Owa, Development and Performance Evaluation of an Indigenous Fish Feed Palletizing Machine , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.