Strength Properties of Stabilised Laterite as Replacement of Sand in Sandcrete Block Production
- Authors
-
-
S. O. Osuji
Department of Civil Engineering, University of Benin, Benin City, Nigeria
-
P. N. Ogbeifun
Department of Civil Engineering, University of Benin, Benin City, Nigeria
-
- Keywords:
- stabilisation, cement, laterite, sand, standards, compressive strength
- Abstract
-
This research borders on the effect of strength on the replacement of sand with stabilized laterite in the production of sandcrete blocks in Benin City. It involves the stabilization of the laterite with 15% cement before being used in the production of sandcrete block. Lateritic soils were obtained from 1m depth in Dentistry Quarters of the University of Benin while sharp sand were drilled from Okhuahia River, in Benin City. The samples were taken to the laboratory where controlled testing and curing. The stabilised laterite was used to gradually replace sand at the rate of 10%, 20%, 30%, 40%, 50% and then completely at 100% in the production of sandcrete blocks. A total 54 sandcrete blocks were prepared in 0.001 m3 mould and cured for 7, 14 and 21 days, after which the compressive strength of the blocks were determined and compared with the Nigerian Industrial standards (NIS) as well as the British standard (BS 2028) for minimum strength considerations. The results of tests carried out indicate that there was an improvement in the strength of the sandcrete block when there was a complete replacement of the stabilized laterite with sand in the production of sandcrete blocks. The least strength results obtained showed that for each percentage replacement of sand with stabilised laterite, the minimum compressive strength exceeded that specified by NIS for block production. This is quite important in reducing the cost of sand in block production.
- References
- Downloads
- Published
- 2019-04-25
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- Catherine Mayowa Ikumapayi, Samuel Lambe Akingbonmire, EFFECTS OF BAMBOO LEAF AND LOCUST BEANS POD ASHES ON AUTOGENOUS SHRINKAGE STRAIN AND COMPRESSIVE STRENGTH OF MORTAR , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- C. M. Ikumapayi, C. Arum, Pozzolanic Influence of Bagasse Ash on the Compressive Strength and Dry Shrinkage of Concrete , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- J. A. Afelumo, O. A. Ademeso, Investigation of the Integrity of Subsoil as Foundation Support for a new Hostel Building, FUT, Akure, Southwestern Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- A. J. Abegunde, B. V. Omidiji, P. O. Ajewole, Characterization of Ado-Ekiti River Sand for foundry applications , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
- D.O. Folorunso, A. A. Akinwande, INFLUENCE OF WOOD SAW DUST AND WASTE GLASS ADMIXTURE ON SELECTED PROPERTIES OF FIRED CLAY BRICKS FOR MASONRY , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- Tasiu Ashiru Sulaiman, Ibrahim Aliyu, Yusuf Yau, Ibrahim Bello, ASSESSMENT OF GROUNDNUT SHELL ASH AND SAWDUST ASH AS PARTIAL REPLACEMENT OF CEMENT IN CONCRETE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 2 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- A. S. Ogbiye, Lucia O. Agashua, Effects of concrete mixing fluid samples - fermented locust beans and sewage on the strength properties of self-healing concrete , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- S. O. Osuji, K. A. Ezekiel, E. O. Kenvin, Effect of Coarse Aggregate Type on the Modulus of Elasticity of Concrete , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 1 (2015): FUTA Journal of Engineering and Engineering Technology
- B. Adebayo, Evaluation of the Performance of Atlas Copco SDR4 Rotary Drill In Sagamu Limestone Formation, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- A. D. Akinwekomi, I. O. Oladele, A. Oyetunji, Microwave Sintering and Characterisation of Magnesium Alloy AZ61/Carbon Nanotube Composites , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.