Soil Quality Analysis for Dumpsite Environment in a University Community in Nigeria
- Authors
-
-
C. O. Akinbile
Department of Agricultural & Environmental Engineering, Federal University of Technology, Akure, Nigeria
-
F. O. Ajibade
Department of Civil & Environmental Engineering, Federal University of Technology, Akure, Nigeria
-
O. Ofuafo
Department of Agricultural & Environmental Engineering, Federal University of Technology, Akure, Nigeria
-
- Keywords:
- Array, Array, Array, Array, Array, Array
- Abstract
-
Physicochemical analyses were carried out on soil samples from four different waste dumpsites in the Federal University of Technology Akure (FUTA), Nigeria to ascertain the effects of the refuse dumpsites on soil and groundwater qualities. Dumpsite locations are Physics Laboratory (PHY), Post Graduate Hostel (PG), School of Earth and Mineral Science (SEMS) and Staff Quarters (STQ). Soil samples collected at distances 0 (dumpsite), 10 and 20 m intervals away from the dumpsite were analyzed and at depths 10, 20 and 30 cm. Parameters determined include pH, Electrical Conductivity (EC), Magnesium (Mg), Calcium (Ca), Sodium (Na), Phosphorus (P), Nitrogen (N), Potassium (K), Organic Carbon (OC), Organic Matter (OM) and heavy metals such as Copper (Cu) and Lead (Pb) and subjected to relevant statistical analysis. Most of the parameters analyzed indicated pollution and were below the Food and Agricultural Organization (FAO) limits. P and Mg concentrations ranged from 1.19 to 1.25mg/kg and 3.17 to 13.61mg/kg respectively which indicated pollution. Out of heavy metals analyzed, Cu was 1.75mg/kg and Pb was not detected. Statistical analysis indicated significant differences at 95% level. The result showed that the soil samples were mildly polluted and therefore not suitable for crop production.
- Author Biography
- References
- Downloads
- Published
- 2019-05-03
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- Engr. Ayoade M. Ajani, Prof. Olugbenga J. Oyedepo, Prof. (Mrs.) Bamitale D. Oluyemi-Ayibiowuwu, Dr. Oladunni. O. Alabi, Engr. Oladapo J. Omomomi, PERFORMANCE AND LIFE-CYCLE COST ANALYSIS OF HYBRID WASTE-MODIFIED ASPHALT CONCRETE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. 2 (2026): FUTA Journal of Engineering and Engineering Technology
- A. D. Akinwekomi, I. O. Oladele, A. Oyetunji, Microwave Sintering and Characterisation of Magnesium Alloy AZ61/Carbon Nanotube Composites , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- M. O. Oyeleye, T. O. Ale, Foundational Steel Reinforcement Earthing Evaluation: Case of Ogomudia Electrical/Electronics Laboratory Building Extension, Federal University Of Technology, Akure , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- C. O. Ijagbemi, Design and Optimization of A Gas Turbine Waste Heat Recovery System , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- Akeju, S. B, Ojo, O. M, Adewumi, J. R. , BOREHOLE WATER QUALITY WITHIN THE FEDERAL UNIVERSITY OF TECHNOLOGY, AKURE, NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 17 No. 1 (2023): FUTA Journal of Engineering and Engineering Technology
- O. O. Olubanjo, A. E. Alade, Development of a Low Cost Greenhouse and Drip Hydroponic Structure for Vegetable Production in South-West Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- O. O. Awopetu, P. K. Farayibi, K. A. Ismail, Optimization of Major Process Parameters for Surface Roughness of ASTM 25 Grey Cast Iron using Taguchi method , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
- E. O. Ajaka, O. E. Abiodun, Determining The Metal Contents of Leach Liqour from Ihietutu Lead and Zinc Ore, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- I. M. Rotimi, T. F. Ajibade, O. O. Femi-Fadeyi, F. O. Ajibae, J. R. Adewunmi, OVERVIEW OF THE NEXUS BETWEEN CLIMATE CHANGE AND POTABLE WATER IN NIGERIA: CHALLENGES AND MITIGATION STRATEGIES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- N. G. Olaiya, P. K. Oke, P. B. Mogaji, Development of A Multipurpose Mix-Sieving Machine , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.