Effects of Wastewaters From an Abattoir on Surface Water Quality in Akure, Ondo State, Nigeria
- Authors
-
-
O. O. Olubanjo
Department of Agricultural and Environmental Engineering, Federal University of Technology Akure, Ondo State, Nigeria
-
- Keywords:
- Array, Array, Array, Array, Array
- Abstract
-
The study examined the effect of Onyearugbulem abattoir wastewaters discharge on surface water quality in Akure. Water samples were taken at three different locations along the receiving water body namely the Upper Course (UC), Middle Course (MC) and the Lower Course (LC). UC samples were collected at the point of entry of the abattoir wastes; MC samples were taken about 50m from the point of entry while LC samples were taken about 100m away from the point of entry of the abattoir waste. The samples were collected, preserved and analyzed in the laboratory using standard methods. The wastewater parameters analyzed were dissolved oxygen (DO), pH, total suspended solid (TSS), total dissolved solid (TDS), biochemical oxygen demand (BOD), chemical oxygen demand (COD), and heavy metals. The mean concentration of 0.24 mg/l for Cr and 0.02 mg/l for Pb exceeded the WHO (1993) and FEPA (1991) standard of 0.1 mg/l Cr and 0.01 mg/l Pb for the discharge of wastewater into river, while the levels of nitrate, TSS and TDS were also higher than the WHO limits for the discharge of wastewater into river. The mean values of 1.9 mg/l, 1626.6 mg/l, 466.67 mg/l and 1666.67 mg/l for DO, COD, TSS and TDS exceeded the WHO permissible limit of ≥5mg/l for DO, N/D for COD, 500 mg/l for TSS and 500 mg/l for TDS for the discharge of wastewater from Onyearugbulem abattoir into the river. Based on the results obtained, the Abattoir Practice Regulatory body should be put in place by the Environmental Protection Agency to regularly regulate and monitor abattoir activities in the study area in order to prevent environmental pollution and health hazards caused by activities of abattoirs.
- References
- Downloads
- Published
- 2019-05-04
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- E. I. Bello, I. A. Daniyan, T. I Ogedengbe, L. Lajide, P. B. Mogaji, Development of a Model for Predicting the Yield of Biodiesel During Biodiesel Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- Ilesanmi, O. A., Egbebiyi, T. S., Oguntunde P. G., Olubanjo, O. O, Akinwumiju, A. S, POTENTIAL IMPACT OF CLIMATE CHANGE ON CROP SUITABILITY IN NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 1 (2024): FUTA Journal of Engineering and Engineering Technology
- OLAJIGA, Samuel Olaniyi, Amu, Olugbenga Oludolapo , EFFECTS OF RICE HUSK ASH ON THE OPTIMUM LIME -STABILIZED LATERITIC SOILS USED FOR ROAD CONSTRUCTION , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 2 (2025): FUTA Journal of Engineering and Engineering Technology
- Ikem, I.A., Akintunde, M. A, Titiladunayo, I. F, Awatt.E, INVESTIGATING THE THERMODYNAMIC CHARACTERISTICS OF ENERGY SAVING REFRIGERATING SYSTEM WITH COLD ACCUMULATOR , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 2 (2025): FUTA Journal of Engineering and Engineering Technology
- Uwadia, O.A., Dahunsi, F.M., SOIL NUTRIENT PREDICTION AND CROP PREDICTION RECOMMENDATION SYSTEMS USING IOT AND AI TECHNIQUES: CURRENT TRENDS AND CHALLENGES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- J. M. Jabar, L. Lajide, A. O. Adetuyi, B. J. Owolabi, G. W. Ayoade, Chemical Modification of Coir, Empty Fruit Bunch and Palm Kernel Fibres for Polymer Reinforcement , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- IDOWU Abimbola Samson , ADEWUYI B.O, FOLORUNSO D.O, AKINWEKOMI A. D., OPTIMUM INFLUENCE OF CHROMIUM AND COMBINE AUSTEMPERING-CRYOGENIC TREATMENTS ON PERFORMANCE OF DUCTILE IRON , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- Agbo, E.R, Olajide, I.A, Itodo, E.S, Faleye, O.P, MACHINE LEARNING FOR ANOMALY DETECTION IN SMART GRID ENERGY CONSUMPTION: A ONE-CLASS SVM APPROACH , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- J. A.V. Famurewa, E. T. Faboya, The Effects of Drying Temperature on the Physicochemical Properties of Ogbono (lrvingia Gabonensis) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- Ajibade Fidelis Odedishemi , SPATIAL ANALYSIS OF URBANIZATION IMPACTS ON WATER RESOURCES USING GEOGRAPHIC INFORMATION SYSTEM IN KANO CITY , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.