Analyses of Biogas and Digestate from Cattle Dung Anaerobic Digestion
- Authors
-
-
S. S. Yaru
Department of Mechanical Engineering, The Federal University of Technology, Akure, Nigeria
-
I. K. Adegun
Department of Mechanical Engineering, University of Ilorin, Ilorin, Nigeria
-
- Keywords:
- Array, Array, Array, Array, Array, Array
- Abstract
-
This paper analyzed biogas and the digestate from cattle dung after anaerobic digestion. Eight kilograms (8 kg) of sun- dried cattle dung mixed with equal volume of water was subjected to anaerobic digestion for 14 days in a digester made of mild steel. The digester had a diameter of 0.3 m, 0.6 m height and 2 mm thickness. The biogas resulting from this setup was daily tested and finally burnt with a blue flame on the 13th day of incubation. The biogas was refined through sodium hydroxide (NaOH) solution. In the chromatographic analysis, the raw biogas produced 56.20% CH4, 39.51% CO2, 1.92% CO, 1.84% H2S and 0.53% NH3. The refined one comprised 70.28% CH4, 27.82% CO2, 1.55% CO, 0.34% H2S and 0.00% NH3. The specific gas constant (Ri) of the biogas increased from 0.3027 kJ/kgK at the raw stage to 0.3459 kJ/kgK when refined. Similarly, the cv improved from 0.9082 kJ/kgK to 1.0376 kJ/kgK that of cp from 1.2080 kJ/kgK to 1.3803 kJ/kgK and the values for the ratio of the specific heats agreed with the standard values of perfect polyatomic and diatomic gases. The calorific values of the biogases in the same order were 19.15MJ/m3 and 22.62MJ/m3. The sun-dried cattle dung and the digestate analyses with atomic absorption spectrophotometer showed respectively 0.13 and 0.20 for Fe (%), 0.49 and 0.55 Ca (%), 0.14 and 0.32 K (%), 0.28 and 0.34 Na (%) and 0.59 and 1.46 P (%) while the values for Co and Mn remained at 0.0001% and 0.03% respectively. The Kjedahl test results for N2 (%) were 1.06 and 1.40 while the oil (%) Soxhlet test results were 2.48 and 0.16 respectively. It was therefore concluded that the digestate had higher values of nutrients than the undigested cattle dung.
- References
- Downloads
- Published
- 2019-05-05
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- I. M. Sanni, H. A. Ahmed, U. A. Abubakar, S. A. Abdullahi, Spatio-Temporal Analysis of Temperature Trend Of Hadeija-Jama’are River of the Chad Basin in Northern Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- Ojo, O.O., Eyiowuawi, B.V., Akinfolarin, J.F., MECHANICAL AND MORPHOLOGICAL FEATURES OF MICROWAVE HYBRID HEATING-INDUCED WELDING OF SS304 STAINLESS STEEL WITH COKE AS A SUSCEPTOR , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 2 (2025): FUTA Journal of Engineering and Engineering Technology
- A. S. Abubakar, Y. A. Sha'aban, Multiple Model Predictive Control for DFIG Based Wind Energy Conversion System , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- Adekoya A. A, Adelabu, O. S. , Kolawole, F. O., DESIGN OF A DUAL DELTA FUSED DEPOSITION MODELLING 3D PRINTER FOR STUDIO CERAMICS PRODUCTION IN NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- S. P. Ayodeji, M. K. Adeyeri, O. O. Oni, Conceptual Design of Battery Powered Vehicle for Children Amusement Park Using Nigerian Anthropometric Parameters , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
- O. A. Adetola, O. J. Olukunle, T. L. Aremu, Investigation of The Effects of Yield On Selected Physical Properties of Cassava Tubers , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 2 (2016): FUTA Journal of Engineering and Engineering Technology
- Adewuyi, Gideon Akinyemi, Daso, Akindele Wellington, Oke, Peter Kayode, INVESTIGATION AND CHARACTERIZATION OF ELEMENTAL COMPOSITION OF SOLAR PANEL , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 2 (2024): FUTA Journal of Engineering and Engineering Technology
- Dafiewhare, O, Ijagbemi, C. O, Ologunwa, T. P, Alabi, O. T, Ijagbemi, A. O, PRODUCTION AND EVALUATION OF BIOMASS BRIQUETTES FROM PALM KERNEL SHELL AND COCONUT HUSK , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 2 (2025): FUTA Journal of Engineering and Engineering Technology
- H. A. Owolabi, B. V. Omidiji, A. O. Oke, A. T. Morakinyo, Development of a Small-Scale Motorized Dough Kneading Machine , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
- Aderinola, O.S, Ata, G.O, ENHANCING ASPHALT PAVEMENT PERFORMANCE THROUGH PALM KERNEL SHELLS (PKS) INTEGRATION , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.