Evaluation of Grid and Off-Grid Energy Consumption
A Case Study of Federal University of Technology, Akure (FUTA)
- Authors
-
-
M. O. Oyeleye
Department of Electrical and Electronics Engineering, Federal University of Technology, Akure, Nigeria
-
- Keywords:
- Array, Array, Array, Array
- Abstract
-
The epileptic nature of power from the grid has necessitated industries and institutions such as Federal University of Technology, Akure (FUTA) to seek and provide alternate source of power therein called Off Grid Supply. This paper evaluates the percentage voltage supply hour from January 2015 to June 2017 of electricity consumption of grid and off-grid supply and its cost implication were evaluated analytically using Voltage Supply Hour (VSH) data for FUTA. The results from the evaluation during the studied years revealed that the electrical energy consumption during the first half of the year from the grid supply is higher than that of the second half of the year. It was also observed that the rate of power outages during the second half year is higher than that of the first half of the year for the grid supply and outages due to faults accounts for majority of the faults as against outages due to load shedding in the institution. Furthermore, the result obtained from comparing the cost when running on the grid supply and off grid supply (diesel generator) shows that off grid supply of diesel generator is at least twice the grid supply. This revalidates that the cost of operating an off- grid supply using diesel generator is costlier than utilizing the grid supply.
- References
- Downloads
- Published
- 2019-11-17
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- Popoola, J. J, Dada, A. B. , deyemi, C. S., A DEEP CONVOLUTIONAL NEURAL NETWORK-BASED MOBILE APPLICATION FOR EARLY AUTO-DETECTION OF PNEUMONIA FROM CHEST X-RAY IMAGES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 2 (2024): FUTA Journal of Engineering and Engineering Technology
- C. O. Ijagbemi, Design and Optimization of A Gas Turbine Waste Heat Recovery System , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- IDOWU Abimbola Samson , ADEWUYI B.O, FOLORUNSO D.O, AKINWEKOMI A. D., OPTIMUM INFLUENCE OF CHROMIUM AND COMBINE AUSTEMPERING-CRYOGENIC TREATMENTS ON PERFORMANCE OF DUCTILE IRON , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- Adeyemo, A. J. , LAND USE EFFECTS ON SOIL CARBON AND NITROGEN ENZYMES IN A HUMID TROPICAL ECOSYSTEMS OF SOUTH WESTERN NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 17 No. 2 (2023): FUTA Journal of Engineering and Engineering Technology
- Oluseyi Orisadare, Ayodeji S. Olawore, Michael O. Ibiwoye, Eyitayo A. Ponle, Omolola T. Odeyemi, Opeyemi S. Kegbeyale, MECHANICAL AND MICROSTRUCTURAL PROPERTIES OF BRASS REINFORCED WITH COCONUT SHELL ASH POWDER , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- Catherine Mayowa Ikumapayi, Samuel Lambe Akingbonmire, EFFECTS OF BAMBOO LEAF AND LOCUST BEANS POD ASHES ON AUTOGENOUS SHRINKAGE STRAIN AND COMPRESSIVE STRENGTH OF MORTAR , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- S. S. Yaru, I. K. Adegun, Analyses of Biogas and Digestate from Cattle Dung Anaerobic Digestion , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
- Ojo, O.O., Eyiowuawi, B.V., Akinfolarin, J.F., MECHANICAL AND MORPHOLOGICAL FEATURES OF MICROWAVE HYBRID HEATING-INDUCED WELDING OF SS304 STAINLESS STEEL WITH COKE AS A SUSCEPTOR , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 2 (2025): FUTA Journal of Engineering and Engineering Technology
- Talabi H. K. , GREEN SYNTHESIS AND CHARACTERIZATION OF COPPER NANOPARTICLES AS REINFORCEMENT IN EPOXY BASED COMPOSITE USING SPONDIAS MOMBIN LEAF EXTRACT , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 2 (2024): FUTA Journal of Engineering and Engineering Technology
- O.O. Ojo,, B.V. Eyiowuawi,, J.F. Akinfolarin,, MECHANICAL AND MORPHOLOGICAL FEATURES OF MICROWAVE HYBRID HEATING-INDUCED WELDING OF SS304 STAINLESS STEEL WITH COKE AS A SUSCEPTOR , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 2 (2015): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.