Investigation of Multilevel Transmission for SI-Plastic Optical Fibre (POF) Channel: PAM and OFDM
- Authors
-
-
W. O. Apena
-
I. Osahon
-
W. O. Popoola
-
- Keywords:
- Array, Array, Array, Array
- Abstract
-
This research studied the choice of Step-Index (SI)Plastic Optical Fibre (POF) as a vital channel for short distance Multilevel (PAM & OFDM) transmission scheme in optical communication system (OCS). This employed initial knowledge on digital modulation to select promised modulation techniques (QPSK-OFDM, 16QAM-OFDM, 2-PAM, and 4-PAM) for POF channel. The controlled experiment was setup in the laboratory using transmitter (LED-L10762, 70MHzand Bias T-ZFBT-4R2GW) and receiver (Photo-receiver) through POF channel length variation (45cm, 30m and 60m) to determine the frequency response (back-to-back) and data rate (DR) performance respectively. Itrevealed disparities in bit error rate (BER) and data rate (DR) performances with respect to distance variation (30m and 60m POF channel). In summary, the bit error rates (BERs) for 30m POF for the chosen modulation techniques are lower compared to 60m POF which shows significance of modulation techniques with respect to POF channel distance. The research shows that POF could be an effective channel for short distance network such as Local Area Network (LAN) and Campus Area Network (CAN) application.
- References
- Downloads
- Published
- 2019-11-17
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- C. C. Chiabuotu, T. E. Abioye, O. M. Olabanji, ENHANCING DEPOSITION QUALITY OF ALUMINUM ALLOY 5356 THROUGH OPTIMIZATION OF WAAM PROCESS PARAMETERS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- T A EWEMOJE, S D FAGBAYIDE, K O OLUWASEMIRE, LYSIMETER DETERMINATION OF CROP COEFFICIENT OF DRIP IRRIGATED JATROPHA CURCAS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- T. S. Mogaji, Development of an Improved Vapour Compression Refrigeration System for Preservation of fresh Vegetables , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- IDOWU Abimbola Samson , ADEWUYI B.O, FOLORUNSO D.O, AKINWEKOMI A. D., OPTIMUM INFLUENCE OF CHROMIUM AND COMBINE AUSTEMPERING-CRYOGENIC TREATMENTS ON PERFORMANCE OF DUCTILE IRON , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- Engr. Ayoade M. Ajani, Prof. Olugbenga J. Oyedepo, Prof. (Mrs.) Bamitale D. Oluyemi-Ayibiowuwu, Dr. Oladunni. O. Alabi, Engr. Oladapo J. Omomomi, PERFORMANCE AND LIFE-CYCLE COST ANALYSIS OF HYBRID WASTE-MODIFIED ASPHALT CONCRETE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. 2 (2026): FUTA Journal of Engineering and Engineering Technology
- E.E. Igbonoba, A. I Edeoghon, THE PERFORMANCE OF DVB-T2 SIGNAL NETWORK IN THE DRY SEASON: A Case Study of Jos in Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- Michael Emoekpere, Olayide R. Adetunji, Femi T. Owoeye, Koya, Abisoye, K., Adewale, T. Samuel, IN VITRO STUDY OF DIFFERENT SAMPLES OF 316 STAINLESS STEEL AS ORTHOPAEDIC BIOCOMPATIBLE MATERIALS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. 1 (2026): FUTA Journal of Engineering and Engineering Technology
- I. M. Rotimi, T. F. Ajibade, O. O. Femi-Fadeyi, F. O. Ajibae, J. R. Adewunmi, OVERVIEW OF THE NEXUS BETWEEN CLIMATE CHANGE AND POTABLE WATER IN NIGERIA: CHALLENGES AND MITIGATION STRATEGIES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- T. B. Afeni, A. I. Lawal, S. J. Omosayin, Evaluation of Alluvial Ore Reserve in an Abandoned Consolidated Tin Mine, Bukuru- Jos Plateau State , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 2 (2015): FUTA Journal of Engineering and Engineering Technology
- J. A. V. Famurewa, C. J. Oladejo, Isotherm Models of Tacca Starch (Tacca Involucrata) at Ambient Temperature Using Some Common Packaging Materials , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 2 (2016): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.