Investigation of the Integrity of Subsoil as Foundation Support for a new Hostel Building, FUT, Akure, Southwestern Nigeria
- Authors
-
-
J. A. Afelumo
-
O. A. Ademeso
-
- Keywords:
- Array, Array, Array, Array
- Abstract
-
This research investigated the integrity of subsoil as foundation for a new building at the Federal University of Technology, Akure, Nigeria. All tests were carried out in accordance with the ASTM, AASHTO and Federal Ministry of Works and Housing standards. Eleven pits were dug while three samples were collected from top, middle and base layers of each pit totaling thirty-three. The results of natural moisture content (NMC) for the top layer averaged 14.7%, percentages of gravel, sand and fines averaged 26.9, 42.1 and 31.0 respectively, liquid limit (LL) 32.45%, plastic limit (PL) 23.8%, plasticity index (PI) 8.4%, linear shrinkage (LS) 8.4%, specific gravity 2.64, maximum dry density (MDD) 1582kg/m3 while optimum moisture content (OMC) averaged 22.7% and shear strength 24.5Kpa. The middle layer has average NMC of 22.37%, percentages of gravel, sand and fines 29.1, 36.4 and 34.5 respectively, LL 37.25%, PL is 24.9%, PI is 10.64%, LS 8.1%, specific gravity 2.66, MDD is 1638.9kg/m3 while the OMC is 20.73% and shear strength is 29.5kpa. Base layer has average NMC of 20.5%, percentages of gravel, sand and fines 24.6, 36.9 and 38.5 respectively, LL 37.6%, PL 25.1%, PI 12.38%, LS 7.3%, specific gravity 2.63, MDD 1768.7kg/m3 while the OMC is 18.7% and shear strength is 32.4kpa. % fines has a very strong positive correlation with LL, PL, PI, MDD, shear strength and UCS while it has a very strong negative with LS and OMC. It was observed that the top soil is non-critical considering the LL specification, while middle and base soils are intermediate. The inadequacy of the top and middle soils was noticed as a result of the non-compact state considering the bearing capacity and shear strength, while the base soil is characterized by fair MDD and high shear strength. Conclusively, the base layer is suitable as support for foundation.
- References
- Downloads
- Published
- 2019-11-17
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- O. O. Daramola, I. O. Oladele, O. S. AKINTAYO, MECHANICAL PROPERTIES OF EPOXY MATRIX COMPOSITES REINFORCED WITH GARLIC PARTICLES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- R. F. Falayi, P. A. Adeduntan, EFFECTS OF WOODASH AND SAWDUST ADMIXTURE ON ENGINEERING PROPERTIES OF BURNT LATERITE CLAY BRICKS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- Olaniyi Alake , COMPRESSIVE STRENGTH OF TERMITE MOUND AND LIME BLENDED CEMENT MORTAR SUBJECTED TO ACIDIC ENVIRONMENT , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 16 No. 1 (2022): FUTA Journal of Engineering and Engineering Technology
- Catherine Mayowa Ikumapayi, Samuel Lambe Akingbonmire, EFFECTS OF BAMBOO LEAF AND LOCUST BEANS POD ASHES ON AUTOGENOUS SHRINKAGE STRAIN AND COMPRESSIVE STRENGTH OF MORTAR , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- C. M. Ikumapayi, C. Arum, Pozzolanic Influence of Bagasse Ash on the Compressive Strength and Dry Shrinkage of Concrete , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- B. Adebayo, Evaluation of the Performance of Atlas Copco SDR4 Rotary Drill In Sagamu Limestone Formation, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- Wilson U.N, Balarabe I, Eze O.C, Adefila A.A, Odeyemi S.O, ASSESEMENT OF COMPRESSIVE STRENGTH OF CONCRETE PRODUCED WITH FINE AGGREGATE FROM DIFFERENT LOCATIONS IN KADUNA STATE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 16 No. 1 (2022): FUTA Journal of Engineering and Engineering Technology
- D.O. Folorunso, A. A. Akinwande, INFLUENCE OF WOOD SAW DUST AND WASTE GLASS ADMIXTURE ON SELECTED PROPERTIES OF FIRED CLAY BRICKS FOR MASONRY , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- E. O. Aiyewalehinmi, O. S. Aderinola, Strength Properties of Commercially Produced Sandcrete block in Ikeja: Lagos State , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 1 (2015): FUTA Journal of Engineering and Engineering Technology
- M. O. Oyeleye, T. O. Ale, Foundational Steel Reinforcement Earthing Evaluation: Case of Ogomudia Electrical/Electronics Laboratory Building Extension, Federal University Of Technology, Akure , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.