Computational Modelling Technique for Short-Term Electric Load Forecasting
- Authors
-
-
A. R. Iyanda
Department of Computer Science and Engineering, Obáfémi Awólówò, University, Ile-Ife, Ósun State
-
O. A. Odejobi
Department of Computer Science and Engineering, Obáfémi Awólówò. University, Ile-Ife, Ósun State
-
- Keywords:
- Array, Array, Array, Array, Array, Array
- Abstract
-
One of the major crises facing developing countries of which Nigeria is not an exception is the problem of epileptic power supply. Fifty years after supposedly seeing the light of independence, Nigerians are still literarily living in the dark. This is due to such factors as poor and insufficient power infrastructure resulting from poor funding, mismanagement of the available power resources (both human and material), vandalism, etc contribute to the above problem. This problem has invariably led to stagnation in the kinds of investments in the country, as power is a crucial component of sustainable development. Hence, the need for developing a computational model that will help to produce a 24-hour forecast of electric load. The design was done using coloured petri net tool and implemented using fuzzy logic tool in Matlab 7. Result showed that percentage electric load consumption for raining season is lower than the one consumed in harmattan, therefore more focus should be given to generating more power during harmattan than during raining season for adequate management of the generated electric power.
- References
- Downloads
- Published
- 2019-04-25
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- Kayode Francis Akingbade, DEVELOPMENT OF CHEMICAL PROPORTION FORMULATION MODEL FOR QUALITY CONTROL IN FLEXIBLE POLYURETHANE FOAM PRODUCTION , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 2 (2018): FUTA Journal of Engineering and Engineering Technology
- K. F. Akingbade, Development of Chemical Proportion Formulation Model for Quality Control in Flexible Polyurethane Foam Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
- Y. O. Olasoji, S. A. Oyetunji, Propagation Path Loss Model for FM Radio Stations In South West, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- O. M. Adebajo, , Prof. Oluyemi-Ayibiowu, B. D. , K. E. Falola, , ASSESSMENT OF SELECTED MACHINE LEARNING SYSTEMS IN PREDICTING THE RESILIENT MODULUS OF COHESIVE SOILS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 2 (2025): FUTA Journal of Engineering and Engineering Technology
- Abdalla Esmaeel, Sesan Peter Ayodeji, Diana Starovoytova, Jerry Ochola, ERGONOMIC RISK SIMULATION USING RAPID UPPER LIMB ASSESSMENT TOOL FOR THE SITTING POSTURE OF GARMENTS WORKERS: A CASE OF RIVATEX EAST AFRICA LIMITED, ELDORET, KENYA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- C. O. Ijagbemi, Design and Optimization of A Gas Turbine Waste Heat Recovery System , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- I. A. Oke, A. O. Obijole, E. A. Adekunbi, J. O. Babajide, M. D. Idi, T. A. Aladesanmi, THERMAL PROPERTY OF CARBON RESIN ELECTRODES DEVELOPED FOR ELECTROCHEMICAL TREATMENT OF WATER AND WASTEWATERS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- Ashiru Mohammed, Ibrahim Aliyu, Hussaini Abdullahi Umar, Aliyu Umar Mani, PERFORMANCE EVALUATION OF RAILWAY BALLAST DEGRADATION USING THE MORPHOLOGICAL PROPERTIES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- Adeyanju, Olusiji Ayoade , Adeosun, Tunde Adamson, PRODUCTION ANALYSIS OF FIVE-SPOT MISCIBLE DISPLACEMENT SCHEMES IN GAS CONDENSATE RESERVOIRS. , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- Tooki, O. O., , Abolade, R. O, Aborisade, D. O., MAPPING OF PLESIOCHRONOUS DIGITAL HIERARCHY SIGNALS INTO SYNCHRONOUS TRANSPORT MODULE FRAME FOR SYNCHRONOUS DIGITAL HIERARCHY SYSTEM , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 17 No. 1 (2023): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.