BRIDGING RESEARCH-INDUSTRY DIVIDE IN FOOD AND BEVERAGE ENTERPRISES: EMPIRICAL EVIDENCE FROM SOUTHWESTERN NIGERIA
- Authors
-
-
A. D. Dada
Federal University of Technology, Akure
-
- Keywords:
- Array
- Abstract
-
This paper investigates the gaps between research institutions and industry in R&D collaboration towards the promotion of innovation, creativity and competitiveness among food and beverage enterprises (FBEs) in Nigeria. This was measured by the level impact of R&D institutional support services for technological innovations in the industry. A multi-staged sampling method was adopted to select 150 registered FBEs from three small and medium scale enterprises (SMEs) populated States in Southwestern Nigeria with a response rate of 64% recorded. Adopting model regression analysis, the study showed that the contributions of R&D institutions to innovative performance of the industry was low (R2 = 0.008). However, training and information dissemination (β=36.49, P≤ 0.05) and provision of analytical services (β = 36.67, P≤ 0.05) were found to have significant impact on the innovative performance of the industry. No significant difference (F=0.336, P≤ 0.05) between the two methods of support services was confirmed in the study. The study concludes that the R&D support services from research institutions to FBEs were inadequate. Policy intervention is needed to encourage R&D institutions to adequately support the food and beverage industry in Nigeria.
- References
- Downloads
- Published
- 2019-04-29
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- T. S. Mogaji, A. Akinsade, M. A. Akintunde, Pyrolysis of Sugarcane Bagasse for Bio-Oil Production
- Taiwo Olabanji, EVALUATION OF DELONIX REGIA SEEDS AS A NATURAL COAGULANT IN THE TREATMENT OF LOW TURBID WATER
- Oyefeso, B, Yusuff, O. A., Fadele, O. K, DEVELOPMENT OF PREDICTIVE MASS AND VOLUME MODELS FOR AFRICAN BUSH MANGO (Irvingia gabonensis) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- Abdalla Esmaeel, Sesan Peter Ayodeji, Diana Starovoytova, Jerry Ochola, ERGONOMIC RISK SIMULATION USING RAPID UPPER LIMB ASSESSMENT TOOL FOR THE SITTING POSTURE OF GARMENTS WORKERS: A CASE OF RIVATEX EAST AFRICA LIMITED, ELDORET, KENYA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- Dahunsi, F. M., , Olawumi, A. O, Sarumi, O. A, Ponnle, A. A, A REVIEW ON ELECTRICAL ENERGY DATASET: MEASUREMENT, FEATURES, AND APPLICATIONS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 17 No. 1 (2023): FUTA Journal of Engineering and Engineering Technology
- Omotoyinbo J.A, Oladele I.O, Oladele I.O, Jabar J.M, Borode J.O, Alaname K.K, Oke S.R., , Omotosho T. F, Atilola F. A. , Saliu L. O., MICROSTRUCTURAL CHARACTERISATION, RHEOLOGICAL AND WATER ABSORPTION PROPERTIES OF FILLED POLYURETHANE FOAM , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 16 No. 1 (2022): FUTA Journal of Engineering and Engineering Technology
- H. A. Owolabi, B. V. Omidiji, O. C. Falade, Optimization of Poultry Feeds Production Using Linear Programming Technique , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 1 (2015): FUTA Journal of Engineering and Engineering Technology
- J J POPOOLA, TECHNICAL AND ECONOMICAL CAMPAIGNS FOR OPPORTUNISTIC RADIO SPECTRUM ACCESS FOR EFFICIENT RADIO SPECTRUM UTILIZATION AND NATIONAL DEVELOPMENT , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- K.F. AKINGBADE, SURVEY OF EXISTING FACE RECOGNITION APPROACHES, TECHNIQUES AND CHALLENGES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 2 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- Uwadia, O.A., Dahunsi, F.M., SOIL NUTRIENT PREDICTION AND CROP PREDICTION RECOMMENDATION SYSTEMS USING IOT AND AI TECHNIQUES: CURRENT TRENDS AND CHALLENGES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
You may also start an advanced similarity search for this article.