CORROSION ASSESSMENT OF SINTER DUPLEX STAINLESS STEEL COMPOSITES IN PINEAPPLE JUICE EXTRACT
- Authors
-
-
O OLANIRAN
Metallurgical & Materials Engineering Department, Federal University of Technology, Akure, Nigeria
-
J O BORODE
Metallurgical & Materials Engineering Department, Federal University of Technology, Akure, Nigeria
-
A E AFOLABI
Metallurgical & Materials Engineering Department, Federal University of Technology, Akure, Nigeria
-
P A OLUBAMBI
Applied Microscopy & Triboelectrochemical Research Laboratory, Tshwane University of Technology, Pretoria, South Africa
-
B A OLANIRAN
Computer Communication Department, Texas Tech University, Lubbock Texas, USA.
-
D O FOLORUNSO
Applied Microscopy & Triboelectrochemical Research Laboratory, Tshwane University of Technology, Pretoria, South Africa
-
- Keywords:
- Array
- Abstract
-
Corrosion behavior of sintered oxide dispersion strengthened duplex stainless steel composites in pineapple juice extract was investigated using weight loss and potentio-dynamic methods. The scope of the work includes investigations on the effects of alloying elements, grain growth inhibitors, varying reinforceing ceramics starting powders. The sinter oxide dispersion strengthened (ODS) samples were characterized, using a combination of varying analytical techniques; scanning electron microscopy (SEM) and x-ray diffractometer (XRD). Gravimetric method is based on weight loss measurement while potentio-dynamic polarization scanning was done using an autolab potentiostat (PGSTAT 204 computer controlled) using the general purpose electrochemical software (GPES) version 1.10. Potentio-dynamic polarization curves were collected by scanning the potential from -1.0 to +1.5 V against Ag/AgCl at a scan rate of 2.0 mV/s. All electrochemical measurements were performed at room temperature in naturally aerated solutions. It was also observed that corrosion rate by gravimetric and polarization scanning provides relatively the same trend of information. Corrosion pits originated from the residual pores and grow as a result of weakening effect by the environment. Inclusions of partially Stabilized Zirconia (PSZ) help prevent further growth of the pits.
- References
- Downloads
- Published
- 2019-04-29
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- I. A. Daniyan, E. I. Bello, T. I. Ogedengbe, L. Lajide, P. B. Mogaji, Development of a Model For Predicting the Yield of Biodiesel During Biodiesel Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 1 (2016): FUTA Journal of Engineering and Engineering Technology
- Talabi H. K. , GREEN SYNTHESIS AND CHARACTERIZATION OF COPPER NANOPARTICLES AS REINFORCEMENT IN EPOXY BASED COMPOSITE USING SPONDIAS MOMBIN LEAF EXTRACT , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 2 (2024): FUTA Journal of Engineering and Engineering Technology
- A. D. Akinwekomi, I. O. Oladele, A. Oyetunji, Microwave Sintering and Characterisation of Magnesium Alloy AZ61/Carbon Nanotube Composites , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- R. Ibrahim, C. O. Akinbile, A. O. Owolabi, K. Ibrahim, REVIEW ON THE POTENTIAL OF BASALT ROCK DUST FOR AGRICULTURAL SOIL MINERALIZATION AND ATMOSPHERIC CARBON SEQUESTRATION , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- O. O. Daramola, I. O. Oladele, O. S. AKINTAYO, MECHANICAL PROPERTIES OF EPOXY MATRIX COMPOSITES REINFORCED WITH GARLIC PARTICLES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- E. I. Bello, I. A. Daniyan, T. I Ogedengbe, L. Lajide, P. B. Mogaji, Development of a Model for Predicting the Yield of Biodiesel During Biodiesel Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- Malomo, B.O., CRASHWORTHINESS AND ENERGY ABSORPTION ANALYSIS OF MESOCARP COIR-FIBRE/EPOXY RESIN-REINFORCED GLASS FIBER HYBRID COMPOSITE LAMINATE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 17 No. 2 (2023): FUTA Journal of Engineering and Engineering Technology
- Daso Akindele Wellington, Adewuyi Gideon Akinyemi, Oke Peter Kayode , DEVELOPMENT OF SOLAR CELLS USING ADAPTABLE LOCALLY SOURCED MATERIALS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 2 (2024): FUTA Journal of Engineering and Engineering Technology
- Oluseyi Orisadare, Ayodeji S. Olawore, Michael O. Ibiwoye, Eyitayo A. Ponle, Omolola T. Odeyemi, Opeyemi S. Kegbeyale, MECHANICAL AND MICROSTRUCTURAL PROPERTIES OF BRASS REINFORCED WITH COCONUT SHELL ASH POWDER , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- A. S. Taiwo, I. O. Oladele, O. O. Daramola, A. D. Akinwekomi, O. G. Agbabiaka, Mechanical Wear Resistance and Water Absorption Properties of Particulate Palm Kernel Shell Reinforced Epoxy Composites for Automobile Application , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.