LYSIMETER DETERMINATION OF CROP COEFFICIENT OF DRIP IRRIGATED JATROPHA CURCAS
- Authors
-
-
T A EWEMOJE
Agricultural and Environmental Engineering Department, University of Ibadan, Nigeria
-
S D FAGBAYIDE
Agricultural and Bio-Environmental Engineering Department, Federal Polytechnic Ilaro, Ogun State, Nigeria
-
K O OLUWASEMIRE
Agronomy Department, University of Ibadan, Nigeria
-
- Keywords:
- Array
- Abstract
-
The study was designed to examine the actual evapotranspiration and crop coefficient (Kc) of eight months old Jatropha curcas grown in mini-drainage lysimeter with a cylindrical drum of circular cross-sectional area of 0.246 m2, diameter 0.56 m and 1.0 m depth. Investigation was conducted with drip irrigation system using five mini lysimeters. Each lysimeter contained one pressure compensating emitter of 4L/hr. Climatic variables were obtained for the determination of reference evapotranspiration (ETo) using the FAO-Penman Monteith model. The value for the crop evapotranspiration (ETc) was determined from the lysimeter using the soil water balance method on daily basis and the crop factor (Kc) was estimated from the ratio of ETc / ETo. The ETo estimated from weather data for the crop growing season ranged from 19.3 to 33.1 mm/day. The average crop coefficient (Kc) values at different growth stages were 0.6, 0.9, 1.2 and 0.8 for the initial, development, mid-season and late season respectively. The research output will enhance the productivity of farmers with optimum water management on large scale Jatropha cultivation.
- References
- Downloads
- Published
- 2019-04-29
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- Obiora-Okeke, O. A, Oladele, A. O , Adewumi, J. R., ASSESSING RAINFALL DATA QUALITY AND TRENDS IN THE SOUTHWESTERN LITTORAL BASIN OF NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 2 (2024): FUTA Journal of Engineering and Engineering Technology
- J. A.V. Famurewa, E. T. Faboya, The Effects of Drying Temperature on the Physicochemical Properties of Ogbono (lrvingia Gabonensis) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- Tasiu Ashiru Sulaiman, Ibrahim Aliyu, Yusuf Yau, Ibrahim Bello, ASSESSMENT OF GROUNDNUT SHELL ASH AND SAWDUST ASH AS PARTIAL REPLACEMENT OF CEMENT IN CONCRETE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 2 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- A. I. Alao, B. K. Adeoye, S. O. Kalu, MICROWAVE-ASSISTED EXTRACTION AND HERBICIDAL POTENTIAL OF CINNAMIC ACID FROM CINNAMON USING RESPONSE SURFACE METHODOLOGY (RSM) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. 1 (2026): FUTA Journal of Engineering and Engineering Technology
- T. I. Mohammed, ACHIEVING THE SELECTION OF OPTIMAL PRESS BRAKE DESIGN VIA A FUZZY TOPSIS APPROACH , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- Dung, M. D.,, Anowai, S.I, Peter, J.A, Dapiya, S.H, Okechalu, J.N, Mawak, J.D, ASSESSMENT OF THE COMPRESSIVE AND SPLITTING TENSILE STRENGTHS OF BIOCONCRETE FROM UREOLYTIC BACTERIA. , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 17 No. 2 (2023): FUTA Journal of Engineering and Engineering Technology
- M. M. Melodi, O. S. Adekinya, Assessment of Cost Effectiveness of Borehole Drilling in Oyo State, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 1 (2016): FUTA Journal of Engineering and Engineering Technology
- O. A. Dahunsi, M. O. Adeoti, O. O. Awopetu, F. O. Aramide, O. O. Alabi, A. S. Abdulkareem, Characterization of Saman-Burkono (Nigeria) Graphite for Crucible Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- IDOWU Abimbola Samson , ADEWUYI B.O, FOLORUNSO D.O, AKINWEKOMI A. D., OPTIMUM INFLUENCE OF CHROMIUM AND COMBINE AUSTEMPERING-CRYOGENIC TREATMENTS ON PERFORMANCE OF DUCTILE IRON , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- E. I. Bello, I. A. Daniyan, T. I Ogedengbe, L. Lajide, P. B. Mogaji, Development of a Model for Predicting the Yield of Biodiesel During Biodiesel Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.