PERFORMANCE EVALUATION OF RUBBER SEED OIL BIODIESEL
- Authors
-
-
E I BELLO
3Department of Mechanical Engineering, the Federal University of Technology, Akure, PMB 704, Ondo State, Nigeria
-
F I OTU
Department of Mechanical Engineering, the Federal University of Technology, Akure, PMB 704, Ondo State, Nigeria
-
T I OGEDENGBE
3Department of Mechanical Engineering, the Federal University of Technology, Akure, PMB 704, Ondo State, Nigeria
-
L LAJIDE
Department of Chemistry, Federal University of Technology, Akure, Ondo State,Nigeria
-
- Keywords:
- Array
- Abstract
-
In this study the engine performance evaluation of synthesized and characterized rubber seed oil biodiesel was carried out at varying engine speeds and different biodiesel blend levels using a four-cylinder, four-stroke Gardner diesel engine rated at 55.93 KW and 435Nm. The engine was operated on pure rubber seed oil biodiesel, biodiesel blends B10, B20, B30 and B40 with baseline diesel fuel as control. Experimental results showed that the brake torque decreased with increasing engine speed and biodiesel blend percentage while the power produced from the biodiesel blends was less than that produced from the diesel fuel. The power produced decreased as the biodiesel blend concentration increases. The maximum power for the biodiesel blended fuels are 55.14kW, 54 31kW, 54.48kW, 53.15kW, 51.17kW and 48.52kW corresponding to B0, B10, B20, B30, B40 and B100 respectively. The break mean effective pressure increased slightly with increasing engine speed and then sharply decreases with increasing engine speed and biodiesel blend concentration. The brake specific fuel consumption and brake thermal efficiency increased with increasing engine speed and increasing biodiesel blend concentration. The results of this investigation can be used for partial replacement of diesel fuel using low concentration of biodiesel (maximum 30%) produced from rubber seed oil thereby reducing the dependence on petroleum- based diesel fuel.
- References
- Downloads
- Published
- 2019-04-28
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- Olabinjo, O. O., , Olusola, G. T. , Sama, M. O., EVALUATION OF PHYSICAL, CHEMICAL AND MICROBIAL PROPERTIES OF DATE FRUIT SEEDS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 1 (2024): FUTA Journal of Engineering and Engineering Technology
- Oluwaseun Opeyemi Martinsa, Muhammad Abdulhamid Mahdia, David Tiwaloluwa Adegokea, Olusola Esther Omoniyia, Pius Benmoore Gabriela, DESIGN AND IMPLEMENTATION OF AN ELECTRONIC ATTENDANCE AND ADMITTANCE SYSTEM WITH FINGERPRINT AUTHENTICATION USING PATTERN MATCHING , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 2 (2024): FUTA Journal of Engineering and Engineering Technology
- Fayose, F, Arowolo, M, Olajide, A., Adewale, D, DESIGN AND PRELIMINARY TESTING OF A SMALL-SCALE CASHEW HARVESTER , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 17 No. 2 (2023): FUTA Journal of Engineering and Engineering Technology
- Adeyanju, Olusiji Ayoade , Adeosun, Tunde Adamson, PRODUCTION ANALYSIS OF FIVE-SPOT MISCIBLE DISPLACEMENT SCHEMES IN GAS CONDENSATE RESERVOIRS. , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- A. I. Alao, B. K. Adeoye, U. Nwitte-Eze, ALKALINE EXTRACTION AND QUALITY ASSESSMENT OF PROTEIN ISOLATE FROM ALMOND (Prunus dulcis) SEED , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- J. A.V. Famurewa, E. T. Faboya, The Effects of Drying Temperature on the Physicochemical Properties of Ogbono (lrvingia Gabonensis) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- A. S. Taiwo, I. O. Oladele, O. O. Daramola, A. D. Akinwekomi, O. G. Agbabiaka, Mechanical Wear Resistance and Water Absorption Properties of Particulate Palm Kernel Shell Reinforced Epoxy Composites for Automobile Application , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- N S Lawal, A A Babalola, O O Adama, A O Sosanya, A A Adebayo, CHARACTERIZATION OF DIFFERENT CASSAVA EFFLUENTS AND EVALUATION OF PROCESSOR ON-SITE HANDLING TECHNIQUES IN OGUN STATE, NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 2 (2018): FUTA Journal of Engineering and Engineering Technology
- SOYOYE Babatunde Oluwamayokun, FALAYI Folayan Richard, OGUNJIMI Jumoke Omowumi, OLORUNFEMI Emmanuel Olasunkanmi, DEVELOPMENT AND PERFORMANCE EVALUATION OF A MOTORIZED BATTERY-POWERED SPRAYER , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- E O Olutomilola, A Omoaka, THEORETICAL DESIGN OF A PLANTAIN PEELING MACHINE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 2 (2018): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.