DEVELOPMENT OF A LOW COST MICROCONTROLLER - BASED HAEMOGLOBIN METER
- Authors
-
-
K D Adedayo
Department of Physics, Federal University of Technology, P. M. B.704, Akure, Ondo State, Nigeria.
-
T Ewetumo
Department of Physics, Federal University of Technology, P. M. B.704, Akure, Ondo State, Nigeria.
-
I Konwea
Department of Physics, Federal University of Technology, P. M. B.704, Akure, Ondo State, Nigeria.
-
T Ewetumo
Department of Physics, Federal University of Technology, P. M. B.704, Akure, Ondo State, Nigeria.
-
- Keywords:
- Array
- Abstract
-
This work looked at the determination of haemoglobin level in the blood using haemoglobin meter; an instrument for determining the absorbance value of haemoglobin in a sample of blood in g/dl.The haemoglobin meter was developed using light emitting diode (LEDs), a phototransistor, operational amplifiers, microcontroller (arduino board), liquid crystal display and a dark compartment. Samples of blood were smeared on a slide that was fixed between the LED and, phototransistor in the dark compartment. The LED emits radiation of visible light that pass through the blood sample which is detected by the phototransistor and is sent to the amplifier that amplifies the signal to a magnitude that can be picked up by the analog to digital converter (ADC) on the arduino board. The digital signal is then programmed by the microcontroller unit and the value is displayed on the liquid crystal display. The meter was calibrated against a standard (SH 120-1) and was examined for the accuracy of haemoglobin level. The developed system performed favourably well with the standard with a correlation value of0.98 at a percentage of 0.01% and the resolution is 0.001 g/dl.
- References
- Downloads
- Published
- 2019-04-28
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- Oluyemi-Ayibiowu B. D, Bello, O, Falola, K. E, A Feasibility Study of Using Electronic Waste as Bitumen Modifier for Sustainable Road Construction and Maintenance , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 2 (2025): FUTA Journal of Engineering and Engineering Technology
- T. B. Afeni, Slope Monitoring using Total Station – a look at the effect of glass shapes on distance measurements with total station , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 1 (2015): FUTA Journal of Engineering and Engineering Technology
- Ogbozige, F.J., APPLICATION OF GIS TECHNIQUES IN GENERATING RAINFALL-IDF MAPS FOR UNGAUGED CATCHMENT: A CASE OF YENAGOA CITY, NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 17 No. 2 (2023): FUTA Journal of Engineering and Engineering Technology
- A. O. Melodi, B. O. Akinloye, Transmission Capacity Enhancement for Nigerian Power Transmission Grid using TCSC and UPFC , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 2 (2014): FUTA Journal of Engineering and Engineering Technology
- D. J. Afu, E. O. Ifelola, S. G. Ayodele, A. Ekun, A. Itunu, Survey of the Effects of Operational Noise on Quarry Workers in Akoko-Edo Local Government Area of Edo State , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
- Babalola, H. I, FACTOR ANALYSIS OF RECRUITMENT AND SELECTION ATTRIBUTES TO PROMOTE WORKFORCE PERFORMANCE IN THE NIGERIAN CONSTRUCTION INDUSTRY , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 2 (2024): FUTA Journal of Engineering and Engineering Technology
- Oyeleye M. O. , Aminu A. k, EVALUATION OF LIGHTNING PROTECTION OF A SOUTH WEST NIGERIA UNIVERSITY LIBRARY EDIFICE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- S. T. Olowolafe, C. M. Ikumapayi, S. L. Akingbonmire, A. A. Olododo, J. A. Ajayi, INFRA-LIGHTWEIGHT CONCRETE: A COMPREHENSIVE REVIEW OF STRUCTURAL AND THERMAL PERFORMANCE WITH SUSTAINABLE AGGREGATES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- Yusuf Ojo Adeiza, Belo Abdullahi, Henry Ohiani Ohize , Momoh Iliyasu Onimisi , DEVELOPMENT OF BIOSORBENT MATERIALS FOR THE REMOVAL OF TOXIC ELEMENTS SOLUBLE PETROLEUM FRACTIONS FROM OIL SPILLEDCONTAMINATED WATER BODY , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- Oyeleye, M. O, Melodi, A. O. , MODELING OF EFFICACIOUS LIGHTNING PROTECTION SCHEME ON NIGERIAN 11-132 kV SUBSTATIONS USING CONE OF PROTECTION METHODS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 17 No. 1 (2023): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.