CHARACTERIZATION OF DIFFERENT CASSAVA EFFLUENTS AND EVALUATION OF PROCESSOR ON-SITE HANDLING TECHNIQUES IN OGUN STATE, NIGERIA
- Authors
-
-
N S Lawal
Department of Agricultural Engineering, College of Engineering and Environmental Studies
-
A A Babalola
Department of Agricultural Engineering, College of Engineering and Environmental Studies, Olabisi Onabanjo University, Ogun State Nigeria.
-
O O Adama
Department of Agricultural Engineering, College of Engineering and Environmental Studies, Olabisi Onabanjo University, Ogun State Nigeria.
-
A O Sosanya
Department of Agricultural Engineering, College of Engineering and Environmental Studies, Olabisi Onabanjo University, Ogun State Nigeria.
-
A A Adebayo
Department of Agricultural Engineering, College of Engineering and Environmental Studies, Olabisi Onabanjo University, Ogun State Nigeria.
-
- Keywords:
- Array
- Abstract
-
Cassava effluent was characterized with the aim of examining the current on-site management techniques among local processors for technological and regulatory improvements. Structured questionnaires were administered in sixty randomly selected processing clusters with different processing capacities to obtain data on the water consumption pattern, effluent output and quality, processing techniques and effluent management. The twenty-three physico-chemical parameters (pH (3.85), Oil and grease (0.386 mg/l), Electrical Conductivity (4.23 µmhos/cm), Biological oxygen demand (1889 mg/l), Total dissolved solids (3240 mg/l), Chemical oxygen demand (752.7 mg/l) Total suspended solids (9.28 mg/l), Bicarbonate (181.6 mg/l), Carbonate (387 mg/l), Sodium (1579.20 mg/l), Total nitrogen (0.86 mg/l), Potassium (1512.49 mg/l), Total Phosphate (300.41 mg/l), Calcium (35.4 mg/l), Magnesium (188.93 mg/l), Lead (59.39 mg/l), Cadmium (Not Detected), Chromium (0.28 mg/l), Iron (3.25 mg/l), Sulphate (17.75 mg/l), Turbidity (7620.96 NTU), Hydrogen Cyanide (678.50 mg/l) and Total Coliform count (2400 cfu/100ml)) analysed were mostly beyond permissible limits prescribed by regulating authorities. Wet fufu paste was the dominant product (73%) and generates the highest volume of wastewater (5-8 liters/tonne of fresh cassava root processed), while gari and fermented cassava flour (lafun) were 21% and 6% respectively. Processing water was predominantly sourced from boreholes (52%); 31% use near by stream water while 16% and 1% rely on water from deep wells and pipe-born water, respectively. On-site effluent handling techniques includes: direct disposal on land (50%), disposal in open drains (37%) and nearby streams (13%). The unwholesome effluent disposal techniques is largely due to the low level of education and processing technology adopted. Precautionary measures and strict regulations are urgently needed to prevent further environmental risk and degradation. Finally, alternative use of treated effluent for crop irrigation should be investigated and promoted to enhance agricultural productivity and economic sustainability among local processors
- References
- Downloads
- Published
- 2019-04-28
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- Oladele, Samouel O. , MICROWAVE THIN-LAYER DRYING KINETICS, DIFFUSIVITY, AND ENERGY EFFICIENCY OF MEDICINAL OCIMUM GRATISSIMUM AND VERNONIA AMYGDALINA LEAVES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- Babalola, H. I, FACTOR ANALYSIS OF RECRUITMENT AND SELECTION ATTRIBUTES TO PROMOTE WORKFORCE PERFORMANCE IN THE NIGERIAN CONSTRUCTION INDUSTRY , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 2 (2024): FUTA Journal of Engineering and Engineering Technology
- O. A. Olubunmi, O. F. Awe, T. R. Ayeni, O. J. Ogundipe, DEVELOPMENT OF A MICROCONTROLLER-DRIVEN OBSTACLE DETECTION AND NAVIGATION SMART EYEGLASSES FOR THE VISUALLY IMPAIRED , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- Engr. Ayoade M. Ajani, Prof. Olugbenga J. Oyedepo, Prof. (Mrs.) Bamitale D. Oluyemi-Ayibiowuwu, Dr. Oladunni. O. Alabi, Engr. Oladapo J. Omomomi, PERFORMANCE AND LIFE-CYCLE COST ANALYSIS OF HYBRID WASTE-MODIFIED ASPHALT CONCRETE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. 2 (2026): FUTA Journal of Engineering and Engineering Technology
- Oladele, S. O., PREDICTION OF PHYSICAL PROPERTIES OF AFRICAN LOCUST BEAN SEEDS (PARKIA BIGLOBOSA) THROUGH NEURAL NETWORK , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 16 No. 1 (2022): FUTA Journal of Engineering and Engineering Technology
- Oladele, Samouel O., COMPARATIVE PROXIMATE COMPOSITION AND TOTAL PHENOLIC CONTENTS OF FOUR Musa CULTIVARS AT UNRIPE AND RIPE STAGES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- Ayodele Temitope OYENIRAN, Olamilekan G. Agbedun, Fatiu O. Agboola, Larry O. Famodimu, Bamiji Z. Adewole, Preliminary Design and Construction of a Small Hydro turbine for Off-Grid Power Generation , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. 2 (2026): FUTA Journal of Engineering and Engineering Technology
- O. A. Agbolade, EVALUATING LORAWAN ADAPTIVE DATA RATE EFFECTIVENESS IN HETEROGENOUS SMART FARMING CONDITIONS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- J. M. Jabar, L. Lajide, A. O. Adetuyi, B. J. Owolabi, G. W. Ayoade, Chemical Modification of Coir, Empty Fruit Bunch and Palm Kernel Fibres for Polymer Reinforcement , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- Ugwu, S. J, Nwude, M. O, Shariff, F. U, ANALYSING THE IMPACT OF URBANISATION ON PHYSICO-CHEMICAL GROUNDWATER PARAMETER OF KADUNA METROPOLIS, USING STATISTICAL APPROACH AND BASIC DRINKING WATER STANDARD , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 17 No. 1 (2023): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.