Appraisal of Risk Identification and Response Techniques adopted on Building Projects in Rivers State, Nigeria
- Authors
-
-
O. A. Awodele
Department of Quantity Surveying, Federal University of Technology, Akure, Ondo State, Nigeria
-
- Keywords:
- Array, Array, Array, Array, Array
- Abstract
-
The performance of the construction industry in terms of meeting its objectives or goal has been invariably affected by risks, thereby leading to time and cost overruns. This research therefore assessed the risk identification and response techniques adopted on building projects in Rivers State, Nigeria with a view to enhancing projects performance in the study area. In achieving the aim of the study, primary data were collected through administration of questionnaires to 284 key construction stakeholders comprising the clients, consultants and contractors on completed public building projects in Rivers State, Nigeria. Out of the 284 questionnaires that were distributed, 158 were returned and found suitable for the analysis. Percentile was used for analyzing demographics of the respondents while mean item score was used for ranking of identified techniques. Kruskal Wallis H test was used for examining the differences in the sample means of different groups of respondents. The study revealed good level of awareness of the existing risk identification and response techniques. it was revealed from the study that utilization of past experience, brainstorming and study of project documents were the most used risk identification techniques while the risk transfer, risk reduction and risk sharing were the most utilized response techniques in building projects. The study recommended that stakeholders should visit locations, consult experts and make reference to databases, and historical data from similar projects during risk identification in order to complement the existing utilized techniques while diligently responding to construction risks in the order of transfer, reduction and avoidance were recommended consequent upon the effectiveness of these strategies.
- References
- Downloads
- Published
- 2019-05-03
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- K. O. Oladosu, E. O. Olafimihan, K. A. Babatunde, B. Kareem, A. A. Mustapha, Investigation of Staged Air supply on Grate Combustion of Palm Kernel Shell Mixed with Selected additives (Al2O3 and CaO) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- W. O. Apena, I. Osahon, W. O. Popoola, Investigation of Multilevel Transmission for SI-Plastic Optical Fibre (POF) Channel: PAM and OFDM , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- I. M. Rotimi, T. F. Ajibade, O. O. Femi-Fadeyi, F. O. Ajibae, J. R. Adewunmi, OVERVIEW OF THE NEXUS BETWEEN CLIMATE CHANGE AND POTABLE WATER IN NIGERIA: CHALLENGES AND MITIGATION STRATEGIES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- Abayomi Olayiwola Eruola, Akeem Makinde, Gbenga Adegboyega Eruola, Kolawole Ayoola, Lugard Nwamini, EFFECT OF FLOAT-WEIGHTS ON DISCHARGE MEASUREMENT , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- Oji, I. C., Ale, T. O, Odeyemi, C. S, MODELLING AND SIMULATION OF FAULTS AND FAULT LOCATION DETECTOR FOR RADIAL DISTRIBUTION SYSTEM , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
- Babalola, H. I, FACTOR ANALYSIS OF RECRUITMENT AND SELECTION ATTRIBUTES TO PROMOTE WORKFORCE PERFORMANCE IN THE NIGERIAN CONSTRUCTION INDUSTRY , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 2 (2024): FUTA Journal of Engineering and Engineering Technology
- B. O. Akinnuli, S. P Ayodeji, S. O. Abadariki, J. O. Fasan, Design, Fabrication and Performance Evaluation of a Reciprocating Cocoa Pod Breaking Machine , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- W. A. Raheem, A. O. Ajayeoba, K. A. Adebiyi, O. R. Oyetunji, O. A. Ayeyemi, Ergonomic Evaluation of Base Transceiver Station Maintenance Personnel in Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- O. Olayemi Simo-Oke, Alaba Ogunbameru, J. Imisi, Bridging Public Infrastructure-Finance Gap in Ondo State, Nigeria: Does Pension Fund Matter? , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 2 (2016): FUTA Journal of Engineering and Engineering Technology
- G. A. Fadehan, K. B. Adedeji, K. F. Akingbae, EFFECT OF FREQUENCY NOTCHING TECHNIQUE ON ULTRA-WIDEBAND ANTENNA PERFORMANCE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. 1 (2026): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.