A Modified Droop Controller for Micro-Grid Power Quality Improvement Using Artificial Fish Swarm Algorithm (AFSA)
- Authors
-
-
Abdulwahab J. Yusuf
Department of Electrical & Computer Engineering; Ahmadu Bello University, Zaria, Nigeria
-
A. A. Olaniyan
Department of Electrical/Electronic Engineering Technology; Auchi Polytechnic, Auchi, Nigeria
-
- Keywords:
- Droop Control, Micro-grid, Artiï¬cial Fish Swarm Algorithm, Frequency Deviation and Voltage Deviation
- Abstract
-
This paper presents a modiï¬ed droop controller for improving the power quality of micro-grid using Artiï¬cial Fish Swarm Algorithm (AFSA). This is necessary in order to reduce the frequency and voltage deviations that occur when the micro-grid changes from grid-connected to an autonomous mode or when the load changes. AFSA was used to optimally select and tune the droop controller gain parameters in order to achieve an improved response in the frequency and voltage outputs of the micro-grid in the course of islanding. The performance of the AFSA-based droop controller was compared with that of the genetic algorithm (GA) based droop controller using the values of frequency and voltage deviations as performance metrics. And from the results obtained, it was observed that the result obtained from the micro-grid when AFSA was used to optimize the droop controller outperforms that obtained when GA was used in terms of frequency and voltage by 0.213% and 1.0453% respectively. All modeling and analysis were implemented in MATLAB 2015b.
- References
- Downloads
- Published
- 2019-11-16
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- M. O. Oyeleye, Evaluation of Grid and Off-Grid Energy Consumption: A Case Study of Federal University of Technology, Akure (FUTA) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- John Macaulay, Brendan Ubochi, IMPLEMENTION OF A DSPACE CONTROL SYSTEM FOR A NON-ISOLATED DC-DC BOOST CONVERTER , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- A. S. Abubakar, Y. A. Sha'aban, Multiple Model Predictive Control for DFIG Based Wind Energy Conversion System , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- A. O. Melodi, B. O. Akinloye, Transmission Capacity Enhancement for Nigerian Power Transmission Grid using TCSC and UPFC , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 2 (2014): FUTA Journal of Engineering and Engineering Technology
- Y. O. Olasoji, Characterization of Noise in Narrowband Power Line Communications , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- I. O. Oladele, O. O. Daramola, A. Oyetunji, Appropriate Technological Procedures for Fusion Welding of Low Alloy Carbon Steel , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- Oyebola Olabinjo, STORABILITY POTENTIAL OF CARROT (Daucuscarota L.) UNDER STEM SPONGE PADDED EVAPORATIVE COOLING STRUCTURES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- M. K. Adeyeri, Proposition of Agent-based Preventive Maintenance Algorithm for Hammer Mill Machine Upkeep , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 1 (2016): FUTA Journal of Engineering and Engineering Technology
- J. J. Popoola, D. O. Akinfenwa, I. O. Animasahun, Assessment of Electromagnetic Radiation Effects and Safety Issues of GSM-900 and GSM-1800 Radio Frequencies – A Case Study of Akure, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 1 (2015): FUTA Journal of Engineering and Engineering Technology
- O. Hezekiah Adeyemi, B Julius Olorunfemi,, Olasunkanmi O Akinyemi, APPRAISAL OF RELATED RISKS WITH LOCALLY MADE BLOCK MAKING MACHINE: A MULTI-SITE CASE STUDY OF NIGERIA BLOCK MAKING INDUSTRY , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 2 (2018): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.