Analysis of Energy Usage Pattern of a Nigerian University Digital Resource Center (DRC):
FUTA DRC as a Case Study
- Authors
-
-
F. M. Dahunsi
Department of Electrical and Electronics Engineering, Federal University of Technology, Akure, Nigeria
-
S. O. Oluponna
Department of Electrical and Electronics Engineering, Federal University of Technology, Akure, Nigeria
-
- Keywords:
- Digital, resource, centre, (DRC)
- Abstract
-
The existing facilities at Digital resource centre (DRC) at the Federal University of Technology, Akure (FUTA) has witnessed unpleasant disasters that claimed valuable properties including structural damage. An electrical power appliance may suffer breakdown or deterioration if it is subjected to an intense working condition above its intended operating capacity. Presently, no known study has been carried out or documented in the management and operation of the DRC under an intense operating condition. Furthermore, the technical requirements of the existing system facilities to meet the demands under prevailing working situation has not been accounted for. This paper adopts historical load consumption data mining using on the spot assessment and exponential regression analysis to determine both the existing and future technical requirements of the facilities at the DRC. Daily energy data were taken using a dedicated energy meter three times daily to determine the peak load hour, plan system maintenance and provide for adequate resources and facilities for smooth system operation. Upon analysis, results showed that the existing electrical facilities at DRC do not have the capacity to meet all the available loads. The existing electrical facilities at DRC can operate up to 45% of the total available loads under good voltage profile supply (maintained at 100% of the nominal values). Under poor voltage profile, the system loading may not operate above 40% to prevent overheating of the electrical cables.
- References
- Downloads
- Published
- 2019-11-17
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- LADI OGUNWOLU, Adeyanju Sosimi, Toheeb Salahudeen, A MULTI-OBJECTIVE RESOURCE-CONSTRAINED PROJECT SCHEDULING PROBLEM USING GENETIC ALGORITHM , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- Abdalla Esmaeel, Sesan Peter Ayodeji, Diana Starovoytova, Jerry Ochola, ERGONOMIC RISK SIMULATION USING RAPID UPPER LIMB ASSESSMENT TOOL FOR THE SITTING POSTURE OF GARMENTS WORKERS: A CASE OF RIVATEX EAST AFRICA LIMITED, ELDORET, KENYA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- K D Adedayo, T Ewetumo, I Konwea, T Ewetumo, DEVELOPMENT OF A LOW COST MICROCONTROLLER - BASED HAEMOGLOBIN METER , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 2 (2018): FUTA Journal of Engineering and Engineering Technology
- S. S. Yaru, I. K. Adegun, M. A. Akintunde, Comparative Study on Ignition Time of Biogas from Cattle Dung and Mixtures of Cattle Dung with Cassava Peels , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 1 (2015): FUTA Journal of Engineering and Engineering Technology
- Ayoola Jongbo, Adekunle T. Atta, Ian Moorcroft, EVALUATION OF THE INDOOR AIR VELOCITY OF A SIDEWALL INLET AND ROOF EXHAUST VENTILATED BROILER SHED USING COMPUTATIONAL FLUID DYNAMICS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- Obinna Obiora-Okeke, J. R. Adewumi, O. M. Ojo, IMPACT OF LAND USE AND LAND COVER CHANGES ON RUNOFF PREDICTION IN OGBESE RIVER WATERSHED , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- P. B. Mogaji, T. E. Abioye, N. O. Ohuruogu, Development of Epoxy Resin Composite Reinforced With Cow Horn and Cassava Particles for Car Dashboard , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- M. O. Oyeleye, T. O. Ale, Foundational Steel Reinforcement Earthing Evaluation: Case of Ogomudia Electrical/Electronics Laboratory Building Extension, Federal University Of Technology, Akure , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- W. O. Apena, I. Osahon, W. O. Popoola, Investigation of Multilevel Transmission for SI-Plastic Optical Fibre (POF) Channel: PAM and OFDM , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- S. S. Yaru, POLLUTION OF VEHICULAR EMISSION ANALYSIS AT FEDERAL UNIVERSITY OF TECHNOLOGY AKURE NORTH GATE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.