DEVELOPMENT OF A LOW COST MICROCONTROLLER - BASED HAEMOGLOBIN METER
- Authors
-
-
K D Adedayo
Department of Physics, Federal University of Technology, P. M. B.704, Akure, Ondo State, Nigeria.
-
T Ewetumo
Department of Physics, Federal University of Technology, P. M. B.704, Akure, Ondo State, Nigeria.
-
I Konwea
Department of Physics, Federal University of Technology, P. M. B.704, Akure, Ondo State, Nigeria.
-
T Ewetumo
Department of Physics, Federal University of Technology, P. M. B.704, Akure, Ondo State, Nigeria.
-
- Keywords:
- Keywords: Haemoglobin, Wavelength, Blood, Light Emitting Diode (LED)
- Abstract
-
This work looked at the determination of haemoglobin level in the blood using haemoglobin meter; an instrument for determining the absorbance value of haemoglobin in a sample of blood in g/dl.The haemoglobin meter was developed using light emitting diode (LEDs), a phototransistor, operational amplifiers, microcontroller (arduino board), liquid crystal display and a dark compartment. Samples of blood were smeared on a slide that was fixed between the LED and, phototransistor in the dark compartment. The LED emits radiation of visible light that pass through the blood sample which is detected by the phototransistor and is sent to the amplifier that amplifies the signal to a magnitude that can be picked up by the analog to digital converter (ADC) on the arduino board. The digital signal is then programmed by the microcontroller unit and the value is displayed on the liquid crystal display. The meter was calibrated against a standard (SH 120-1) and was examined for the accuracy of haemoglobin level. The developed system performed favourably well with the standard with a correlation value of0.98 at a percentage of 0.01% and the resolution is 0.001 g/dl.
- References
- Downloads
- Published
- 2019-04-28
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- A. E. Owoputi, Issues in Safety and Security in Maritime Transportation, Port and Marine Environment , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 2 (2014): FUTA Journal of Engineering and Engineering Technology
- J. J. Popoola, D. O. Akinfenwa, I. O. Animasahun, Assessment of Electromagnetic Radiation Effects and Safety Issues of GSM-900 and GSM-1800 Radio Frequencies – A Case Study of Akure, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 1 (2015): FUTA Journal of Engineering and Engineering Technology
- A. R. Iyanda, O. A. Odejobi, Computational Modelling Technique for Short-Term Electric Load Forecasting , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 2 (2015): FUTA Journal of Engineering and Engineering Technology
- E. O. Ajaka, O. C. Chukwuma, Promax2100: A Computer Programme for Design and Optimization of Mineral Processing Plant , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- I. O. Oladele, O. O. Daramola, A. Oyetunji, Appropriate Technological Procedures for Fusion Welding of Low Alloy Carbon Steel , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- A. P. Olalusi, M. S. Obot, A. S. Ogunlowo, Modelling the Dehydration Characteristics of Taro (Colocasia Esculenta) Slices in a Convective Cabinet Dryer , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- C. O. Ijagbemi, D. T. Oloruntoba, A. O. Adeoye, Development of a Bioplastic Film for Food Packaging , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- A. S. Ojo, M. O. Alatise, Spatial Variability of Soil Physical Properties of a Typical Fadama Farmland (Ayede Ogbese) in South Western, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- B. O. Akinnuli, S. P Ayodeji, S. O. Abadariki, J. O. Fasan, Design, Fabrication and Performance Evaluation of a Reciprocating Cocoa Pod Breaking Machine , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- T. O. Ale, Evaluation of Akure 132kV Transformer Substation Load Growth Trend , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.