Determining The Metal Contents of Leach Liqour from Ihietutu Lead and Zinc Ore, Nigeria
- Authors
-
-
E. O. Ajaka
Department of Mining Engineering, School of Engineering and Engineering Technology, Federal University of Technology Akure, Nigeria.
-
O. E. Abiodun
Department of Mining Engineering, School of Engineering and Engineering Technology, Federal University of Technology Akure, Nigeria.
-
- Keywords:
- autogenous grindability, media assisted grindability, new mass charged mode, addition of difference charged mode, leaching, microwave pretreatment, smelting
- Abstract
-
This study characterized and recovered metals from Ihietutu lead-zinc sample Galena grains are interlocked with sphalerite and gangue minerals. Autogenous and media assisted grinding tests were studied in addition of difference and new mass charged modes. Gravity method for the production of a concentrate was also carried out using spiral separator with optimum recovery at +600 µm and highest loss at +125-53 µm. Also, the rate of leaching increased with time and an average of 88 g and 125 g was leached into the solution after three days for microwave pretreated and as-mined ore respectively. The final leachate contains 150 mg Pb/kg, 34 mg Zn/kg in aqua regia as-mined, 185 mg Pb/kg, 54.25 mg Zn/kg in aqua regia microwave pretreated, 137.20 mg Pb/kg, 21.50 mg Zn/kg in H2SO4 as-mined and 160.40 mg Pb/kg, 37.67 mg Zn/kg in H2SO4 microwave pretreated. The result from leaching revealed that aqua-regia has stronger ability for better yield than sulphuric acid in both microwave pretreated sample and as-mined sample respectively. Weight loss during roasting was 3.81%.
- References
- Downloads
- Published
- 2020-04-09
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- Catherine Mayowa Ikumapayi, Samuel Lambe Akingbonmire, EFFECTS OF BAMBOO LEAF AND LOCUST BEANS POD ASHES ON AUTOGENOUS SHRINKAGE STRAIN AND COMPRESSIVE STRENGTH OF MORTAR , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- Adebayo Felix Owa, Daniel Toyin Oloruntoba, Muideen Adebayo Bodude, Fisayo Adesina, INVESTIGATION OF MILD STEEL PROTECTION WITH GLASS WOOL IN CORROSIVE MEDIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 2 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- M. M. Melodi, O. S. Adekinya, Assessment of Cost Effectiveness of Borehole Drilling in Oyo State, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 1 (2016): FUTA Journal of Engineering and Engineering Technology
- T. B. Afeni, Slope Monitoring using Total Station – a look at the effect of glass shapes on distance measurements with total station , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 1 (2015): FUTA Journal of Engineering and Engineering Technology
- A. D. Akinwekomi, I. O. Oladele, A. Oyetunji, Microwave Sintering and Characterisation of Magnesium Alloy AZ61/Carbon Nanotube Composites , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- S. O. Balogun, S. A. Yaro, M. Abdulwahab, A. Kasim, PRODUCTION AND CHARACTERIZATION OF ALUMINA NANOPARTICLES FROM GIRO CLAY VIA ACID LEACHING WITH SOL GEL METHOD , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- Olatunji Oladimeji Ojo, Taban Emel, ASSESSMENT OF EFFECTIVE NUGGET SIZE, NUGGET ROTATION AND FAILURE MODE OF FRICTION STIR SPOT WELDS OF AA2219-O ALLOY , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- D.O. Folorunso, A. A. Akinwande, INFLUENCE OF WOOD SAW DUST AND WASTE GLASS ADMIXTURE ON SELECTED PROPERTIES OF FIRED CLAY BRICKS FOR MASONRY , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- A. P. Olalusi, Comparison of Selected Engineering Properties of Two Species of Cocoyam Essential for Handling of the Tubers , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 2 (2014): FUTA Journal of Engineering and Engineering Technology
- J. Isa, M. A. Aderotoye, Effect of moisture content on the physical and aerodynamics properties of cashew nut , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.