Design, Fabrication and Performance Evaluation of a Reciprocating Cocoa Pod Breaking Machine

• B. O. Akinnuli

  School Engineering and Engineering Technology, Akure

• S. P Ayodeji

  Federal University of Technology, Akure, Nigeria.

• S. O. Abadariki

  Federal University of Technology, Akure, Nigeria.

• J. O. Fasan

  Federal University of Technology, Akure, Nigeria.

After harvesting ripped cocoa pods during primary processing the next operation is the extraction of the wet seeds from their pods before fermentation. This operation of wet seed extraction is commonly performed manually using cutlass for cutting into two and using of hands for the extraction of the set seeds. This caused drudgery, low extraction rate and atimes incised wounds from cutlass used. Hence an electrically or fueled reciprocating engine powered cocoa pods breaking machine was designed, fabricated and evaluated. It has a crushing chamber of 0.054m3, hammer mass of 15.38 kg, applied force of 150.92 N for breaking pods, rated power of the prime mover (electric motor or fueled engine) is 1.22 kW, diameter of hammer's shaft is 28.0 mm, the angle of hopper is 210 using mild steel of 5 mm gauge with friction coefficient of 0.32, total mass of the machine is 145 kg with attached accessories and its geometric dimension is (1060 x 690 x 460) mm. It's crushing capacity per hour based on size ofpods are 7,600, 5,400 and 3,600 for small, medium and large pods respectively. Its efficiency based on the pod classifications are: small pods 92.5%, medium pods 87% while the large size is 86.25%. The cost of the machine considering: material, machining, bought out goods, non – machining and labour costs amount to five hundred and twenty-four US dollar US $524:00.

1. B. O. Akinnuli, School Engineering and Engineering Technology, Akure
   Department of Mechanical Engineering Federal University of Technology, Akure, Nigeria
2. S. P Ayodeji, Federal University of Technology, Akure, Nigeria.
   Department of Mechanical Engineering
3. S. O. Abadariki, Federal University of Technology, Akure, Nigeria.
   Department of Mechanical Engineering
4. J. O. Fasan, Federal University of Technology, Akure, Nigeria.
   Department of Mechanical Engineering

• PDF

Copyright

With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.