EXPERIMENTAL STUDY ON THE SYNERGISTIC EFFECTS OF COOLING METHODS AND HEAT SINK DESIGN ON THERMOELECTRIC GENERATOR PERFORMANCE

• C. N. Udekwe

  Department of Information and Communication Engineering, Federal University of Technology, Akure, Ondo State, Nigeria

• A. A. Ponnle

  Department of Electrical and Electronics Engineering, Federal University of Technology, Akure, Ondo State, Nigeria

• A. O. Omolade

  Department of Electrical and Electronics Engineering, Federal University of Technology, Akure, Ondo State, Nigeria

Thermoelectric generators (TEGs) are a promising option for recovering waste heat into electricity, particularly in low-power applications. However, their performance is often limited by poor heat management, inefficient cooling at the cold side, and substandard material choices. This paper investigates the performance of different heat sink configurations which are the, High-Density Fin Aluminum Alloy (HDFA) and Extruded Aluminum Fin Alloy (EAFA), on a thermoelectric generator (TEG) module and tested under different temperature differences and cooling options such as the ice cooling and fan cooling. The study analyzes the impact of temperature difference on voltage, current, and power output of the thermoelectric generator to determine the most effective heat sink configuration and cooling technique for optimizing thermoelectricity generation. Experimental results showed that the HDFA consistently performed better than the EAFA across all trials which demonstrates higher voltage, current, and power output. Additionally, ice cooling was more effective than fan cooling which generates more power by maintaining higher temperature difference. Results also indicated a direct correlation between power output and temperature difference, further validating how important heat management is in thermoelectric energy conversion. Despite these promising results, some limitations were found such as, controlled laboratory conditions that was used in the experiments that may not fully represent real-world applications. Further research should explore alternative thermoelectric materials, hybrid cooling techniques, and dynamic environmental conditions. These results contribute to the advancements of thermoelectric generators (TEGs) modules, while further supporting their applications into renewable energy systems. Finally, selecting better heat sink materials and cooling techniques would help accelerate the technologies for waste heat recovery and renewable energy systems.

• PDF

Copyright (c) 2026 FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Copyright

With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.