LYSIMETER DETERMINATION OF CROP COEFFICIENT OF DRIP IRRIGATED JATROPHA CURCAS
- Authors
-
-
T A EWEMOJE
Agricultural and Environmental Engineering Department, University of Ibadan, Nigeria
-
S D FAGBAYIDE
Agricultural and Bio-Environmental Engineering Department, Federal Polytechnic Ilaro, Ogun State, Nigeria
-
K O OLUWASEMIRE
Agronomy Department, University of Ibadan, Nigeria
-
- Keywords:
- Mini-drainage lysimeter, soil water balance, Jatropha crop coefficient and drip irrigation
- Abstract
-
The study was designed to examine the actual evapotranspiration and crop coefficient (Kc) of eight months old Jatropha curcas grown in mini-drainage lysimeter with a cylindrical drum of circular cross-sectional area of 0.246 m2, diameter 0.56 m and 1.0 m depth. Investigation was conducted with drip irrigation system using five mini lysimeters. Each lysimeter contained one pressure compensating emitter of 4L/hr. Climatic variables were obtained for the determination of reference evapotranspiration (ETo) using the FAO-Penman Monteith model. The value for the crop evapotranspiration (ETc) was determined from the lysimeter using the soil water balance method on daily basis and the crop factor (Kc) was estimated from the ratio of ETc / ETo. The ETo estimated from weather data for the crop growing season ranged from 19.3 to 33.1 mm/day. The average crop coefficient (Kc) values at different growth stages were 0.6, 0.9, 1.2 and 0.8 for the initial, development, mid-season and late season respectively. The research output will enhance the productivity of farmers with optimum water management on large scale Jatropha cultivation.
- References
- Downloads
- Published
- 2019-04-29
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- Olufemi Adeyemi Adetola, M. J. Odu, THE DEVELOPMENT OF A HAND-PUSH WEEDER FOR CUTTING WEEDS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- J. O. BABAJIDE, E. O. FEHINTOLA, T. A. ALADESANMI, M. D. IDI, E. A. ADEKUNBI, I. A. OKE, E. O. OBIJOLE, NEWTON RAPHSON SOLUTIONS OF BIOCHEMICAL OXYGEN DEMAND (BOD) KINETICS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- O. S. Oyerinde, John A. V. Olumurewa, D. Fajobi, DRYING KINETICS OF FISH (Clarias gariepinus) SMOKED WITH BIOGAS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- Taiwo Olabanji, EVALUATION OF DELONIX REGIA SEEDS AS A NATURAL COAGULANT IN THE TREATMENT OF LOW TURBID WATER , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- O. O. Olubanjo, Effects of Wastewaters From an Abattoir on Surface Water Quality in Akure, Ondo State, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- A. P. Olalusi, M. S. Obot, A. S. Ogunlowo, Modelling the Dehydration Characteristics of Taro (Colocasia Esculenta) Slices in a Convective Cabinet Dryer , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- A. S. Taiwo, I. O. Oladele, O. O. Daramola, A. D. Akinwekomi, O. G. Agbabiaka, Mechanical Wear Resistance and Water Absorption Properties of Particulate Palm Kernel Shell Reinforced Epoxy Composites for Automobile Application , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- C. O. Ijagbemi, D. T. Oloruntoba, A. O. Adeoye, Development of a Bioplastic Film for Food Packaging , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- Ochuko Mary Ojo, J O Babatola, A A Adesina, A O Akinola, Olurinde Lafe, SYNERGISTIC EFFECT OF CO-DIGESTING DIFFERENT MIX RATIOS OF WATER HYACINTH AND COW-DUNG FOR BIOGAS PRODUCTION. , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- Abayomi Olayiwola Eruola, Akeem Makinde, Gbenga Adegboyega Eruola, Kolawole Ayoola, Lugard Nwamini, EFFECT OF FLOAT-WEIGHTS ON DISCHARGE MEASUREMENT , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.