PERFORMANCE EVALUATION OF RUBBER SEED OIL BIODIESEL
- Authors
-
-
E I BELLO
3Department of Mechanical Engineering, the Federal University of Technology, Akure, PMB 704, Ondo State, Nigeria
-
F I OTU
Department of Mechanical Engineering, the Federal University of Technology, Akure, PMB 704, Ondo State, Nigeria
-
T I OGEDENGBE
3Department of Mechanical Engineering, the Federal University of Technology, Akure, PMB 704, Ondo State, Nigeria
-
L LAJIDE
Department of Chemistry, Federal University of Technology, Akure, Ondo State,Nigeria
-
- Keywords:
- rubber seed oil biodiesel, performance evaluation, biodiesel blend, diesel engine
- Abstract
-
In this study the engine performance evaluation of synthesized and characterized rubber seed oil biodiesel was carried out at varying engine speeds and different biodiesel blend levels using a four-cylinder, four-stroke Gardner diesel engine rated at 55.93 KW and 435Nm. The engine was operated on pure rubber seed oil biodiesel, biodiesel blends B10, B20, B30 and B40 with baseline diesel fuel as control. Experimental results showed that the brake torque decreased with increasing engine speed and biodiesel blend percentage while the power produced from the biodiesel blends was less than that produced from the diesel fuel. The power produced decreased as the biodiesel blend concentration increases. The maximum power for the biodiesel blended fuels are 55.14kW, 54 31kW, 54.48kW, 53.15kW, 51.17kW and 48.52kW corresponding to B0, B10, B20, B30, B40 and B100 respectively. The break mean effective pressure increased slightly with increasing engine speed and then sharply decreases with increasing engine speed and biodiesel blend concentration. The brake specific fuel consumption and brake thermal efficiency increased with increasing engine speed and increasing biodiesel blend concentration. The results of this investigation can be used for partial replacement of diesel fuel using low concentration of biodiesel (maximum 30%) produced from rubber seed oil thereby reducing the dependence on petroleum- based diesel fuel.
- References
- Downloads
- Published
- 2019-04-28
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- F I OTU, E I BELLO, T I OGEDENGBE, L LAJIDE, FOURIER TRANSFORM INFRARED SPECTROSCOPIC ANALYSIS OF RUBBER SEED OIL AND ITS BIODIESEL , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- B. O. Akinnuli, S. P Ayodeji, S. O. Abadariki, J. O. Fasan, Design, Fabrication and Performance Evaluation of a Reciprocating Cocoa Pod Breaking Machine , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 1 (2014): FUTA Journal of Engineering and Engineering Technology
- S. O. Obayopo, F. J. Banjoko, S. A. Balogun, H. B. Adedayo, Investigation into the Use of Blended Sunflower Oil and Superolein in Hydraulic Systems , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- I. A. Daniyan, E. I. Bello, T. I. Ogedengbe, L. Lajide, P. B. Mogaji, Development of a Model For Predicting the Yield of Biodiesel During Biodiesel Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 1 (2016): FUTA Journal of Engineering and Engineering Technology
- O P FAPETU, A O AKINOLA, L L LAJIDE, A B OSASONA, PHYSICOCHEMICAL CHARACTERISTICS STUDY OF OIL EXTRACTED FROM RAFFIA PALM SEED , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- E. I. Bello, I. A. Daniyan, T. I Ogedengbe, L. Lajide, P. B. Mogaji, Development of a Model for Predicting the Yield of Biodiesel During Biodiesel Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- A. M. Akintade, O. J. Olukunle, J. Isa, Performance Evaluation of an Electromechanical Groundnut Roasting Machine Akintade A.M, Olukunle O. J. and Isa J. , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 2 (2014): FUTA Journal of Engineering and Engineering Technology
- M. A. Azeez, O. Oluwaseyi, A. A. Ajiboye, A. Iwayemi, Performance Evaluation of A Reverse Aodv And Aodv Routing Protocol Under Jellyfish Attacks in Mobile Ad Hoc Network , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 1 (2016): FUTA Journal of Engineering and Engineering Technology
- B. Adebayo, Evaluation of the Performance of Atlas Copco SDR4 Rotary Drill In Sagamu Limestone Formation, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- M. O. Oyeleye, Evaluation of Grid and Off-Grid Energy Consumption: A Case Study of Federal University of Technology, Akure (FUTA) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.