PERFORMANCE EVALUATION OF RUBBER SEED OIL BIODIESEL
- Authors
-
-
E I BELLO
3Department of Mechanical Engineering, the Federal University of Technology, Akure, PMB 704, Ondo State, Nigeria
-
F I OTU
Department of Mechanical Engineering, the Federal University of Technology, Akure, PMB 704, Ondo State, Nigeria
-
T I OGEDENGBE
3Department of Mechanical Engineering, the Federal University of Technology, Akure, PMB 704, Ondo State, Nigeria
-
L LAJIDE
Department of Chemistry, Federal University of Technology, Akure, Ondo State,Nigeria
-
- Keywords:
- Array
- Abstract
-
In this study the engine performance evaluation of synthesized and characterized rubber seed oil biodiesel was carried out at varying engine speeds and different biodiesel blend levels using a four-cylinder, four-stroke Gardner diesel engine rated at 55.93 KW and 435Nm. The engine was operated on pure rubber seed oil biodiesel, biodiesel blends B10, B20, B30 and B40 with baseline diesel fuel as control. Experimental results showed that the brake torque decreased with increasing engine speed and biodiesel blend percentage while the power produced from the biodiesel blends was less than that produced from the diesel fuel. The power produced decreased as the biodiesel blend concentration increases. The maximum power for the biodiesel blended fuels are 55.14kW, 54 31kW, 54.48kW, 53.15kW, 51.17kW and 48.52kW corresponding to B0, B10, B20, B30, B40 and B100 respectively. The break mean effective pressure increased slightly with increasing engine speed and then sharply decreases with increasing engine speed and biodiesel blend concentration. The brake specific fuel consumption and brake thermal efficiency increased with increasing engine speed and increasing biodiesel blend concentration. The results of this investigation can be used for partial replacement of diesel fuel using low concentration of biodiesel (maximum 30%) produced from rubber seed oil thereby reducing the dependence on petroleum- based diesel fuel.
- References
- Downloads
- Published
- 2019-04-28
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- Malomo, B.O., CRASHWORTHINESS AND ENERGY ABSORPTION ANALYSIS OF MESOCARP COIR-FIBRE/EPOXY RESIN-REINFORCED GLASS FIBER HYBRID COMPOSITE LAMINATE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 17 No. 2 (2023): FUTA Journal of Engineering and Engineering Technology
- M O Idris, EVALUATION OF EFFECTS OF EXTERNAL FACTORS ON DUE DATES PREDICTION IN MANUFACTURING JOBSHOPS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 2 (2018): FUTA Journal of Engineering and Engineering Technology
- W. O. Apena, G. A. Oladunni, Comparative Analysis of Path Loss Prediction Models for Selected Rural Areas in Ondo State, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- Babatunde Oluwamayokun Soyoye, Abeebullah Bayonle Oguntayo, Peter Adeniyi Adeduntan, Timothy Oluwadamilare Adisa, Mobile Machine Learning Application for Early Detection of Cassava Diseases , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. 1 (2026): FUTA Journal of Engineering and Engineering Technology
- Ayoola Jongbo, Adekunle T. Atta, Ian Moorcroft, EVALUATION OF THE INDOOR AIR VELOCITY OF A SIDEWALL INLET AND ROOF EXHAUST VENTILATED BROILER SHED USING COMPUTATIONAL FLUID DYNAMICS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- O. Olayemi Simo-Oke, Alaba Ogunbameru, J. Imisi, Bridging Public Infrastructure-Finance Gap in Ondo State, Nigeria: Does Pension Fund Matter? , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 2 (2016): FUTA Journal of Engineering and Engineering Technology
- Oyebola Olabinjo, STORABILITY POTENTIAL OF CARROT (Daucuscarota L.) UNDER STEM SPONGE PADDED EVAPORATIVE COOLING STRUCTURES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- Ifelola Eyitayo Oluwaseyi , EVALUATION OF THE EFFICACY OF ACTIVATED CARBON TREATMENT OF OLAIJA COAL MINE SURROUNDING WATER BODIES, BENUE STATE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 1 (2024): FUTA Journal of Engineering and Engineering Technology
- Alfred, V. A, Saliu, M. A, Omoegun, S.O. , Odeyemi, O. Y. , ASSESSMENT OF OXIDE PROPERTIES OF CLAY DEPOSITS FROM ANAMBRA GEOLOGICAL BASIN FOR THEIR SUITABILITY AS CERAMIC RAW MATERIALS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 17 No. 1 (2023): FUTA Journal of Engineering and Engineering Technology
- Oji, I. C., Ale, T. O, Odeyemi, C. S, MODELLING AND SIMULATION OF FAULTS AND FAULT LOCATION DETECTOR FOR RADIAL DISTRIBUTION SYSTEM , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 19 No. 1 (2025): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.