COMPARATIVE ANALYSIS OF THE USE OF BAMBOO STEM ASH AND CEMENT FOR LATERITIC SOIL STABILIZATION
- Authors
-
-
O. ADERINLEWO
Federal University of Technology, Akure, Nigeria
-
B. ARIBISALA
Federal Polytechnic, Department of Civil Engineering Technology, Ede, P.M.B. 231, Nigeria
-
A. AFOLAYAN
Federal University of Technology, Akure, Nigeria
-
M. TANIMOLA
Department of Civil Engineering
-
- Keywords:
- Geotechnical Properties, Stabilizer, Atterberg Limits, California Bearing Ratio, Compressive Strength
- Abstract
-
In this paper, the stabilizing effects of bamboo stem ash (BSA) on the geotechnical properties of lateritic soil are assessed and compared with effects of cement on the same soil. Laboratory tests such as natural moisture content, specific gravity, Atterberg limits, California bearing ratio (CBR) and unconfined compressive strength (UCS) were carried out on the soil samples in accordance with specified standards both before and after the bamboo stem ash and cement were added separately in varying proportions of 2%, 4%, 6%, 8% and 10% by weight of soil. The Optimum Moisture Content increased from 19.43% at 0% to 22.00% at 10% BSA stabilizer while the Maximum Dry Density reduced from 1.78 g/cm3 to 1.59 g/cm3 at 6% BSA but later increased to 1.72 g/cm3. The unsoaked CBR value of the soil in its natural state was 17.23% and it rose to 21.85% on addition of 10% bamboo stem ash by weight of soil. The unconfined compressive strength improved from 149.68 kPa in the natural state to 269.42 kPa at 10% bamboo stem ash content. Overall, the results of the analyses showed that the bamboo stem ash enhanced the properties of the lateritic soil.
- References
- Downloads
- Published
- 2020-11-25
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- J. Isa, M. A. Aderotoye, Effect of moisture content on the physical and aerodynamics properties of cashew nut , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
- J. O. BABAJIDE, E. O. FEHINTOLA, T. A. ALADESANMI, M. D. IDI, E. A. ADEKUNBI, I. A. OKE, E. O. OBIJOLE, NEWTON RAPHSON SOLUTIONS OF BIOCHEMICAL OXYGEN DEMAND (BOD) KINETICS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- T O Awodola, FLEXURAL MOTION UNDER MOVING MASSES OF PRESTRESSED SIMPLY SUPPORTED PLATE RESTING ON BI-PARAMETRIC FOUNDATION , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- I. A. Daniyan, E. I. Bello, T. I. Ogedengbe, L. Lajide, P. B. Mogaji, Development of a Model For Predicting the Yield of Biodiesel During Biodiesel Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 1 (2016): FUTA Journal of Engineering and Engineering Technology
- T. O. Awodola, Dynamic Behaviour Under Moving Masses of Prestressed and Elastically Supported Plates Resting on Winkler Foundation , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 1 (2015): FUTA Journal of Engineering and Engineering Technology
- E. I. Bello, I. A. Daniyan, T. I Ogedengbe, L. Lajide, P. B. Mogaji, Development of a Model for Predicting the Yield of Biodiesel During Biodiesel Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- J S. Ajiboye, B. A. Okey-Amechi, Influence of Accumulative back Extrusion and Lubricants on the Hardness of Al 6063 Alloy , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 2 (2015): FUTA Journal of Engineering and Engineering Technology
- K. O. Oladosu, E. O. Olafimihan, K. A. Babatunde, B. Kareem, A. A. Mustapha, Investigation of Staged Air supply on Grate Combustion of Palm Kernel Shell Mixed with Selected additives (Al2O3 and CaO) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- J. A.V. Famurewa, E. T. Faboya, The Effects of Drying Temperature on the Physicochemical Properties of Ogbono (lrvingia Gabonensis) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- E.O. OLUKANNI, O.J. OYEDEPO, PHYSICO-RHEOLOGICAL CHARACTERIZATION OF POLYMER MODIFIED BITUMEN , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 2 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
You may also start an advanced similarity search for this article.