Strength Properties of Stabilised Laterite as Replacement of Sand in Sandcrete Block Production
- Authors
-
-
S. O. Osuji
Department of Civil Engineering, University of Benin, Benin City, Nigeria
-
P. N. Ogbeifun
Department of Civil Engineering, University of Benin, Benin City, Nigeria
-
- Keywords:
- stabilisation, cement, laterite, sand, standards, compressive strength
- Abstract
-
This research borders on the effect of strength on the replacement of sand with stabilized laterite in the production of sandcrete blocks in Benin City. It involves the stabilization of the laterite with 15% cement before being used in the production of sandcrete block. Lateritic soils were obtained from 1m depth in Dentistry Quarters of the University of Benin while sharp sand were drilled from Okhuahia River, in Benin City. The samples were taken to the laboratory where controlled testing and curing. The stabilised laterite was used to gradually replace sand at the rate of 10%, 20%, 30%, 40%, 50% and then completely at 100% in the production of sandcrete blocks. A total 54 sandcrete blocks were prepared in 0.001 m3 mould and cured for 7, 14 and 21 days, after which the compressive strength of the blocks were determined and compared with the Nigerian Industrial standards (NIS) as well as the British standard (BS 2028) for minimum strength considerations. The results of tests carried out indicate that there was an improvement in the strength of the sandcrete block when there was a complete replacement of the stabilized laterite with sand in the production of sandcrete blocks. The least strength results obtained showed that for each percentage replacement of sand with stabilised laterite, the minimum compressive strength exceeded that specified by NIS for block production. This is quite important in reducing the cost of sand in block production.
- References
- Downloads
- Published
- 2019-04-25
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- O. O. Alabi, T. A. Olatunji, Y. Gbadamosi, Geochemical and Mineralogical Characterization of Ore – Mineral Assemblages from Black Sands in Akure South Area, South - Western Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- P. B. Mogaji, T. E. Abioye, N. O. Ohuruogu, Development of Epoxy Resin Composite Reinforced With Cow Horn and Cassava Particles for Car Dashboard , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- Samuel L Akingbonmire, L Samuel, O Oluwafemi Omotayo, J O Afolayan, A Banjo Olorunshola, THE PHYSICO-CHEMICAL PROPERTIES OF SOME FINE AGGREGATES IN LOKOJA, NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 2 (2018): FUTA Journal of Engineering and Engineering Technology
- J. O. Amigun, Seismic Inverted Acoustic Impedance for Lithofacies Discrimination and Reservoir Fluids Prediction: A Case of ‘Ovi’ Field, Niger Delta , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- W. O. Apena, G. A. Oladunni, Comparative Analysis of Path Loss Prediction Models for Selected Rural Areas in Ondo State, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- E.E. Igbonoba, A. I Edeoghon, THE PERFORMANCE OF DVB-T2 SIGNAL NETWORK IN THE DRY SEASON: A Case Study of Jos in Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- I. O. Oladele, O. G. Agbabiaka, A. S. Ogunbadejo, M. A. Okoro, Assessment of Mechanical Properties of Hybrid Composites Based on Polypropylene and Vegetable Fibers , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 2 (2015): FUTA Journal of Engineering and Engineering Technology
- Y. O. Olasoji, S. A. Oyetunji, Propagation Path Loss Model for FM Radio Stations In South West, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- A. P. Olalusi, Comparison of Selected Engineering Properties of Two Species of Cocoyam Essential for Handling of the Tubers , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 2 (2014): FUTA Journal of Engineering and Engineering Technology
- J. J. Popoola, D. O. Akinfenwa, I. O. Animasahun, Assessment of Electromagnetic Radiation Effects and Safety Issues of GSM-900 and GSM-1800 Radio Frequencies – A Case Study of Akure, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 1 (2015): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.