Spatial Variability of Soil Physical Properties of a Typical Fadama Farmland (Ayede Ogbese) in South Western, Nigeria
- Authors
-
-
A. S. Ojo
Federal University of Technology Akure
-
M. O. Alatise
Federal University of Technology Akure
-
- Keywords:
- Irrigation systems, Agricultural production, Soil physical properties, spatial variability, Fadama land
- Abstract
-
Spatial variability of soil physical properties of Fadama land in Ayede-Ogbese, Ondo state, Nigeria was investigated to determine the suitable irrigation system for the agricultural land. Soil samples at varying depths 0 – 30, 30 – 60 and 60 – 90cm were collected and analyzed using standard methods and procedures. The coordinate of each of the points were obtained with GPS (Global Positioning System). The physical properties investigated include: textural class, bulk density, particle density and moisture content. Others were water holding capacity, total porosity, hydraulic conductivity and organic matter content. Results showed that the soil of the study area belongs to four different textural classes: sandy loam, clay loam, clay and sandy clay loam. The sandy clay loam was dominant with46% proportion of the prevalent soil textural class in the study area. The mean values for bulk density and moisture content across the depth of 0 – 90cm were (1.30 ± 0.1) g/cm3 and (17.4% ± 7.10) respectively. The mean values for Water Holding Capacity and the Hydraulic Conductivity were (26.2% ± 4.37) and (0.26cm/hr ± 0.13) respectively. The average mean values of soil parameters within the study area were within acceptable limit for optimum agricultural production (FAO/IIASA, 2008). Hence the soil physical properties obtainable at Ayede-Ogbese Fadama land are suitable for the design of sprinkler and drip as appropriate irrigation systems for the study area (FAO/IIASA, 2008).
- Author Biographies
- References
-
Abou, Z. M. (2000). Egypt water resources management and polices.Al-Mohandseen Magazine, pp.528-535.
Alatise M.O. (2004) a. Evaluation of Inputs for Investment in the Fadama Scheme to Boost Crop Production in Ondo State. A paper presented to the Annual Conference of the Nigerian Institution of Agricultural Engineers held between 22th and 26th November, at Kwara Hotels Limited, Ilorin, Kwara State, pp. 12 - 45
Alatise M.O. (2004) b. Growth; Yield and Water use Pattern of Maize under variable Limited Water Supply. Journal of Applied Science, Engineering and Technology 4(1):3-6
Arvidson, J. (2001). Subsoil compaction caused by heavy sugerbeet harvesters in Southern Sweden. Soil physical properties and crop yield in six field experiments. Soil Tillage Research. 7(4): 32- 41
Blake, G.R. and Hartge, K.H. (1986). Bulk density in: A. Klute (Ed.). Methods of Soil Analysis. Part 1. Physical and Mineralogical Methods. 2nd.Ed. Agronomy No. 9 (part 1). ASA9 SSSA. Madison, Wisconsin, USA, pp 363-375.
Brady, N.C. (1990): The Nature and Properties of Soils. Macmillan Publishing Company, NY, pp. 89 – 99.
Brady, N.C. and Weil, R.R., (1999).The Nature and Properties of Soils 12th Edition Macmillan Publishing Company, pp. 146 – 174
FAO. (1979). Soil Survey investigation for irrigation soils. New York: John Wiley and sons Inc.
FAO/IIASA, (2008). “Harmonized World Soil Database†version 1.0, FAO, Rome, Italy & ASA, Laxenburg, Austria
Franzmeier, D.P., Lemme G.D. and Miles R.J. (1995): Organic Carbon in Soils of North Central United States Soil Science Society America Journal. 49: 702-708.
Herbst, M., Diekkruger, B. and Vanderborght, J. (2006): Numerical experiments on the sensitivity of runoff generation to the Journal. Hydrology, 326, 43-58.
Jagtab, S.S and Alabi, R.T. (1997). Reliability of daily, weekly and monthly grass evaporation using hourly estimates by Penman method in three agro-ecological zones of West Africa Nigeria, Management Journal. 2(1): 59-68
Medredev, T.H. (1998): Soil Aggregate Distribution and Soil Porosity. Harry Gray, pp.32.
Minasny, B. and McBratney, A.B. (2007): Estimating the Water Retention Shape Parameter from Sand and Clay Content. Soil Science Society of America Journal, 71, 1105-1110.
Rich, K. and Von, I. (2010) Utah State University, USA, Extension and Agriculture Department: Guidelines for Soil Quality, pp. 60
Shein and Mizury, (1998): Soil Physical Properties 5th Ed., Butterworld Publications, London, pp 53- 60.
Wardrop Engineering Incorporated (1992). Kwara State Agricultural Development Programme, Federal Agricultural Coordinating Unit. Notes on training sessions. Fadama Field Training Programme, pp. 2 - 4.
Zhang, R. (1997). “Determination of soil sorptivity and hydraulic infiltrometer.â€Soil Sci. Soc. Am. J. 61: 1024-1030
- Downloads
- Published
- 2019-01-02
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- Y. O. Olasoji, Characterization of Noise in Narrowband Power Line Communications , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- I. A. Daniyan, E. I. Bello, T. I. Ogedengbe, L. Lajide, P. B. Mogaji, Development of a Model For Predicting the Yield of Biodiesel During Biodiesel Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 1 (2016): FUTA Journal of Engineering and Engineering Technology
- Olanrewaju Oluwafemi Akinfala, Emmanuel Enyeribe Ege, Ladi Folorunso Ogunwolu, ARRIVAL PATTERNS AND TRAFFIC FLOW CHARACTERISTICS AT SIGNALIZED INTERSECTIONS: CONSIDERING UPSTREAM SIGNAL INFLUENCE AND TIME RESOLUTIONS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- J S. Ajiboye, B. A. Okey-Amechi, Influence of Accumulative back Extrusion and Lubricants on the Hardness of Al 6063 Alloy , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 2 (2015): FUTA Journal of Engineering and Engineering Technology
- J. A.V. Famurewa, E. T. Faboya, The Effects of Drying Temperature on the Physicochemical Properties of Ogbono (lrvingia Gabonensis) , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- J. A. Afelumo, O. A. Ademeso, Investigation of the Integrity of Subsoil as Foundation Support for a new Hostel Building, FUT, Akure, Southwestern Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- F. O. Ajibade, J. R. Adewumi, Performance Evaluation of Aquatic Macrophytes in a Constructed Wetland for Municipal Wastewater Treatment , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- M. M. Melodi, T. G. Onipede, Economic Appraisal of Some Selected Quarries Operation in Ondo State, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
- S. S. Yaru, I. K. Adegun, M. A. Akintunde, Comparative Study on Ignition Time of Biogas from Cattle Dung and Mixtures of Cattle Dung with Cassava Peels , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 1 (2015): FUTA Journal of Engineering and Engineering Technology
- O. Adukwu, E. D. Oku, O. I. Apeh, Bivariate Empirical Modeling of Global System for Mobile-Communication (GSM) Propagation Path Loss in an Undulating Terrain , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 2 (2018): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.