Spatial Variability of Soil Physical Properties of a Typical Fadama Farmland (Ayede Ogbese) in South Western, Nigeria
- Authors
-
-
A. S. Ojo
Federal University of Technology Akure
-
M. O. Alatise
Federal University of Technology Akure
-
- Keywords:
- Irrigation systems, Agricultural production, Soil physical properties, spatial variability, Fadama land
- Abstract
-
Spatial variability of soil physical properties of Fadama land in Ayede-Ogbese, Ondo state, Nigeria was investigated to determine the suitable irrigation system for the agricultural land. Soil samples at varying depths 0 – 30, 30 – 60 and 60 – 90cm were collected and analyzed using standard methods and procedures. The coordinate of each of the points were obtained with GPS (Global Positioning System). The physical properties investigated include: textural class, bulk density, particle density and moisture content. Others were water holding capacity, total porosity, hydraulic conductivity and organic matter content. Results showed that the soil of the study area belongs to four different textural classes: sandy loam, clay loam, clay and sandy clay loam. The sandy clay loam was dominant with46% proportion of the prevalent soil textural class in the study area. The mean values for bulk density and moisture content across the depth of 0 – 90cm were (1.30 ± 0.1) g/cm3 and (17.4% ± 7.10) respectively. The mean values for Water Holding Capacity and the Hydraulic Conductivity were (26.2% ± 4.37) and (0.26cm/hr ± 0.13) respectively. The average mean values of soil parameters within the study area were within acceptable limit for optimum agricultural production (FAO/IIASA, 2008). Hence the soil physical properties obtainable at Ayede-Ogbese Fadama land are suitable for the design of sprinkler and drip as appropriate irrigation systems for the study area (FAO/IIASA, 2008).
- Author Biographies
- References
-
Abou, Z. M. (2000). Egypt water resources management and polices.Al-Mohandseen Magazine, pp.528-535.
Alatise M.O. (2004) a. Evaluation of Inputs for Investment in the Fadama Scheme to Boost Crop Production in Ondo State. A paper presented to the Annual Conference of the Nigerian Institution of Agricultural Engineers held between 22th and 26th November, at Kwara Hotels Limited, Ilorin, Kwara State, pp. 12 - 45
Alatise M.O. (2004) b. Growth; Yield and Water use Pattern of Maize under variable Limited Water Supply. Journal of Applied Science, Engineering and Technology 4(1):3-6
Arvidson, J. (2001). Subsoil compaction caused by heavy sugerbeet harvesters in Southern Sweden. Soil physical properties and crop yield in six field experiments. Soil Tillage Research. 7(4): 32- 41
Blake, G.R. and Hartge, K.H. (1986). Bulk density in: A. Klute (Ed.). Methods of Soil Analysis. Part 1. Physical and Mineralogical Methods. 2nd.Ed. Agronomy No. 9 (part 1). ASA9 SSSA. Madison, Wisconsin, USA, pp 363-375.
Brady, N.C. (1990): The Nature and Properties of Soils. Macmillan Publishing Company, NY, pp. 89 – 99.
Brady, N.C. and Weil, R.R., (1999).The Nature and Properties of Soils 12th Edition Macmillan Publishing Company, pp. 146 – 174
FAO. (1979). Soil Survey investigation for irrigation soils. New York: John Wiley and sons Inc.
FAO/IIASA, (2008). “Harmonized World Soil Database†version 1.0, FAO, Rome, Italy & ASA, Laxenburg, Austria
Franzmeier, D.P., Lemme G.D. and Miles R.J. (1995): Organic Carbon in Soils of North Central United States Soil Science Society America Journal. 49: 702-708.
Herbst, M., Diekkruger, B. and Vanderborght, J. (2006): Numerical experiments on the sensitivity of runoff generation to the Journal. Hydrology, 326, 43-58.
Jagtab, S.S and Alabi, R.T. (1997). Reliability of daily, weekly and monthly grass evaporation using hourly estimates by Penman method in three agro-ecological zones of West Africa Nigeria, Management Journal. 2(1): 59-68
Medredev, T.H. (1998): Soil Aggregate Distribution and Soil Porosity. Harry Gray, pp.32.
Minasny, B. and McBratney, A.B. (2007): Estimating the Water Retention Shape Parameter from Sand and Clay Content. Soil Science Society of America Journal, 71, 1105-1110.
Rich, K. and Von, I. (2010) Utah State University, USA, Extension and Agriculture Department: Guidelines for Soil Quality, pp. 60
Shein and Mizury, (1998): Soil Physical Properties 5th Ed., Butterworld Publications, London, pp 53- 60.
Wardrop Engineering Incorporated (1992). Kwara State Agricultural Development Programme, Federal Agricultural Coordinating Unit. Notes on training sessions. Fadama Field Training Programme, pp. 2 - 4.
Zhang, R. (1997). “Determination of soil sorptivity and hydraulic infiltrometer.â€Soil Sci. Soc. Am. J. 61: 1024-1030
- Downloads
- Published
- 2019-01-02
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- A. D. Akinwekomi, I. O. Oladele, A. Oyetunji, Microwave Sintering and Characterisation of Magnesium Alloy AZ61/Carbon Nanotube Composites , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- Ayoola Jongbo, Adekunle T. Atta, Ian Moorcroft, EVALUATION OF THE INDOOR AIR VELOCITY OF A SIDEWALL INLET AND ROOF EXHAUST VENTILATED BROILER SHED USING COMPUTATIONAL FLUID DYNAMICS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- H. A. Owolabi, B. V. Omidiji, A. O. Oke, A. T. Morakinyo, Development of a Small-Scale Motorized Dough Kneading Machine , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
- S. O. Balogun, S. A. Yaro, M. Abdulwahab, A. Kasim, PRODUCTION AND CHARACTERIZATION OF ALUMINA NANOPARTICLES FROM GIRO CLAY VIA ACID LEACHING WITH SOL GEL METHOD , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- M. M. Melodi, D. A. Agboola, Labour Productivity Assessment of Dredging Operations in Some Selected Companies in Lagos State, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- N G Olaiya, P K Farayibi, P K Oke, A REVIEW ON ADDITIVE MANUFACTURING: LASER TECHNOLOGY METHODS, DISTINCTIONS AND APPLICATIONS IN MANUFACTURING ENGINEERING , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 2 (2018): FUTA Journal of Engineering and Engineering Technology
- F. M. Dahunsi, S. O. Oluponna, Analysis of Energy Usage Pattern of a Nigerian University Digital Resource Center (DRC):: FUTA DRC as a Case Study , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- Folasade Dahunsi, Oluwasina Aderinwale, Abayomi Adesida, Abiola Alayande, J. Ojo, Oluwaseyi Falola, Oluwarotimi Dahunsi, DEVELOPMENT OF A SPACE TECHNOLOGY CAPACITY BUILDING INITIATIVE AT THE FEDERAL UNIVERSITY OF TECHNOLOGY, AKURE, NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- O. O. Awopetu, Effect of Rake Face Reinforcement on Cutting Tool Life of Cemented Carbide Tools during Turning of a-Titanium Alloy , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
- J. O. BABAJIDE, E. O. FEHINTOLA, T. A. ALADESANMI, M. D. IDI, E. A. ADEKUNBI, I. A. OKE, E. O. OBIJOLE, NEWTON RAPHSON SOLUTIONS OF BIOCHEMICAL OXYGEN DEMAND (BOD) KINETICS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
You may also start an advanced similarity search for this article.