LYSIMETER DETERMINATION OF CROP COEFFICIENT OF DRIP IRRIGATED JATROPHA CURCAS
- Authors
-
-
T A EWEMOJE
Agricultural and Environmental Engineering Department, University of Ibadan, Nigeria
-
S D FAGBAYIDE
Agricultural and Bio-Environmental Engineering Department, Federal Polytechnic Ilaro, Ogun State, Nigeria
-
K O OLUWASEMIRE
Agronomy Department, University of Ibadan, Nigeria
-
- Keywords:
- Mini-drainage lysimeter, soil water balance, Jatropha crop coefficient and drip irrigation
- Abstract
-
The study was designed to examine the actual evapotranspiration and crop coefficient (Kc) of eight months old Jatropha curcas grown in mini-drainage lysimeter with a cylindrical drum of circular cross-sectional area of 0.246 m2, diameter 0.56 m and 1.0 m depth. Investigation was conducted with drip irrigation system using five mini lysimeters. Each lysimeter contained one pressure compensating emitter of 4L/hr. Climatic variables were obtained for the determination of reference evapotranspiration (ETo) using the FAO-Penman Monteith model. The value for the crop evapotranspiration (ETc) was determined from the lysimeter using the soil water balance method on daily basis and the crop factor (Kc) was estimated from the ratio of ETc / ETo. The ETo estimated from weather data for the crop growing season ranged from 19.3 to 33.1 mm/day. The average crop coefficient (Kc) values at different growth stages were 0.6, 0.9, 1.2 and 0.8 for the initial, development, mid-season and late season respectively. The research output will enhance the productivity of farmers with optimum water management on large scale Jatropha cultivation.
- References
- Downloads
- Published
- 2019-04-29
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- M. D. IDI, T. A. ALADESANMI, S. LUKMAN, M. A. ASANI, Y. M. USMAN, I. A. OKE, A NUMERICAL FORMULA AND COST BENEFIT OF GROUNDWATER RECHARGE IN MAIDUGURI, NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 2 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- E. O. Aiyewalehinmi, O. S. Aderinola, Strength Properties of Commercially Produced Sandcrete block in Ikeja: Lagos State , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 9 No. 1 (2015): FUTA Journal of Engineering and Engineering Technology
- Bamiji Zacheous Adewole, EXPERIMENTAL STUDY ON BED-TO-TUBE HEAT TRANSFER COEFFICIENTS IN BUBBLING FLUIDIZED BED , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- J. A. Afelumo, O. A. Ademeso, Investigation of the Integrity of Subsoil as Foundation Support for a new Hostel Building, FUT, Akure, Southwestern Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- I. A. Daniyan, E. I. Bello, T. I. Ogedengbe, L. Lajide, P. B. Mogaji, Development of a Model For Predicting the Yield of Biodiesel During Biodiesel Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 10 No. 1 (2016): FUTA Journal of Engineering and Engineering Technology
- A. E. Owoputi, Issues in Safety and Security in Maritime Transportation, Port and Marine Environment , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 8 No. 2 (2014): FUTA Journal of Engineering and Engineering Technology
- Kayode Francis Akingbade, DEVELOPMENT OF CHEMICAL PROPORTION FORMULATION MODEL FOR QUALITY CONTROL IN FLEXIBLE POLYURETHANE FOAM PRODUCTION , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 2 (2018): FUTA Journal of Engineering and Engineering Technology
- S. S. Yaru, I. K. Adegun, Analyses of Biogas and Digestate from Cattle Dung Anaerobic Digestion , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 2 (2017): FUTA Journal of Engineering and Engineering Technology
- T E Abioye, DEVELOPMENT OF A POULTRY DE-FEATHERING MACHINE WITH AN ADJUSTABLE BASIN , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- J. M. Jabar, L. Lajide, A. O. Adetuyi, B. J. Owolabi, G. W. Ayoade, Chemical Modification of Coir, Empty Fruit Bunch and Palm Kernel Fibres for Polymer Reinforcement , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 11 No. 1 (2017): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.