Multiple Model Predictive Control for DFIG Based Wind Energy Conversion System
- Authors
-
-
A. S. Abubakar
Department of Electrical Engineering, Ahmadu Bello University, Zaria Nigeria
-
Y. A. Sha'aban
Department of Electrical Engineering, Ahmadu Bello University, Zaria Nigeria
-
- Keywords:
- Array, Array, Array, Array
- Abstract
-
This work developed a multiple input multiple output model predictive control scheme based, for a grid connected wind turbine system with a view to extracting the maximum power from a doubly fed induction generator (DFIG) under an unbalanced condition. The work employed a MMPC scheme for controlling the generator torque and pitch angle simultaneously, so as to reduces the mechanical stress, flicker emission, drive train load and effectively exploit the advantage of high penetration of wind farm. The control strategy was formulated for the whole operating region of the wind turbine system both low and high-speed regime. In addition, multiple model predictive control comprising different MPC was designed based on the operating wind speed. A baseline controller using gain scheduled proportional-integral controller was implemented on a GE 1.5 MW Wind turbine system was used to validate the effectiveness of the developed controller. Based on results obtained, a reduction in 11.04% and 22.42% in flicker emission and drive train load was obtained for the MMPC as compared to PI controller of 0.540752 and 0.216369 respectively at low speed regime (6 m/s). Whilst at high speed regime (16 m/s) the MMPC recorded a reduction in flicker emission and drive train load of 65.36% and 65.21% respectively as compared to baseline controller of 0.032236 and 0.032236 respectively. The performance of the MMPC outperforms the standard baseline in tracking the desire set points using realistic wind speed model with a reduction in both flicker emission and drive train load
- References
- Downloads
- Published
- 2019-05-14
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- S. S. Yaru, POLLUTION OF VEHICULAR EMISSION ANALYSIS AT FEDERAL UNIVERSITY OF TECHNOLOGY AKURE NORTH GATE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 1 (2021): FUTA Journal of Engineering and Engineering Technology
- Brendan Ubochi, DEVELOPMENT OF AN ELECTRIC POWER OUTAGE MONITORING AND LOGGING SYSTEM , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 18 No. 2 (2024): FUTA Journal of Engineering and Engineering Technology
- Oyebola Olabinjo, STORABILITY POTENTIAL OF CARROT (Daucuscarota L.) UNDER STEM SPONGE PADDED EVAPORATIVE COOLING STRUCTURES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- Oluseyi Orisadare, Ayodeji S. Olawore, Michael O. Ibiwoye, Eyitayo A. Ponle, Omolola T. Odeyemi, Opeyemi S. Kegbeyale, MECHANICAL AND MICROSTRUCTURAL PROPERTIES OF BRASS REINFORCED WITH COCONUT SHELL ASH POWDER , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- R. F. Falayi, P. A. Adeduntan, EFFECTS OF WOODASH AND SAWDUST ADMIXTURE ON ENGINEERING PROPERTIES OF BURNT LATERITE CLAY BRICKS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- T. S. Mogaji, A. Akinsade, M. A. Akintunde, Pyrolysis of Sugarcane Bagasse for Bio-Oil Production , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- Iniko E. Bassey, Prof. Josiah O. Babatola, Prof. O. M. Ojo, Ebenezer O. Onagbola, EVALUATING THE EFFICIENCY OF TERMITE-MEDIATED DEGRADATION OF SUGARCANE BAGASSE, MAIZE COBS, AND COCONUT HUSKS FOR BIOGAS PRODUCTION , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. 2 (2026): FUTA Journal of Engineering and Engineering Technology
- O P FAPETU, A O AKINOLA, L L LAJIDE, A B OSASONA, PHYSICOCHEMICAL CHARACTERISTICS STUDY OF OIL EXTRACTED FROM RAFFIA PALM SEED , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- O. O. Alabi, T. A. Olatunji, Y. Gbadamosi, Geochemical and Mineralogical Characterization of Ore – Mineral Assemblages from Black Sands in Akure South Area, South - Western Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 1 (2019): FUTA Journal of Engineering and Engineering Technology
- Satimehin, A., Fayose, F, Adewale D, Adewoyin. O, EFFECT OF EXTRUSION PROCESS ON PERFORMANCE OF AN INDIGENOUS EXTRUDER AND QUALITY OF CASSAVA PRODUCTS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 16 No. 1 (2022): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.