Comparative Analysis of Path Loss Prediction Models for Selected Rural Areas in Ondo State, Nigeria
- Authors
-
-
W. O. Apena
Department of Electrical and Electronic Engineering, The Federal University of Technology, Akure. Nigeria
-
G. A. Oladunni
Biomedical Computing and Engineering Technology, Applied Research Group, Coventry University, Coventry, United Kingdom
-
- Keywords:
- Array, Array, Array, Array
- Abstract
-
The paper presents a comparison between the path loss prediction model derived for selected area in Ondo State, Nigeria and some existing models in the research empirical study was adopted due to the complexity of the terrain involved. Six of the existing models were used to investigate signal strength of Ondo State Radio-vision Corporation (OSRC) Television Signal in the rural areas of Idanre-Owena, Ondo State, Nigeria. The calculated path loss values were compared with measured data to obtain signal strength from Akure-Idanre via Owena route in Ondo State, Nigeria using root mean square errors (RMSEs) prediction performance (10-15 dB). The RMSEs results (14.5dB-25.0dB) showed that none of the six models values are close to the spot measured values. The study revealed that OSRC TV signal is cut off from major area in Idanre, therefore their frequency could be co-used by other service provider, in this area alone, to enhance links such as provision of broadband services to this area.
- References
- Downloads
- Published
- 2019-11-17
- Section
- Articles
- License
-
Copyright
With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.
How to Cite
Similar Articles
- W. O. Apena, I. Osahon, W. O. Popoola, Investigation of Multilevel Transmission for SI-Plastic Optical Fibre (POF) Channel: PAM and OFDM , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 13 No. 2 (2019): FUTA Journal of Engineering and Engineering Technology
- Ayoola Jongbo, Adekunle T. Atta, Ian Moorcroft, EVALUATION OF THE INDOOR AIR VELOCITY OF A SIDEWALL INLET AND ROOF EXHAUST VENTILATED BROILER SHED USING COMPUTATIONAL FLUID DYNAMICS , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- Adeyi, T. A, Sadiq, T. O, Olawore, A. S, Diji, C. J, INVESTIGATION OF OPTIMAL DRYING MEDIA FOR SELECTED AGRICULTURAL PRODUCE IN NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 16 No. 2 (2022): FUTA Journal of Engineering and Engineering Technology
- Oyebola Olabinjo, STORABILITY POTENTIAL OF CARROT (Daucuscarota L.) UNDER STEM SPONGE PADDED EVAPORATIVE COOLING STRUCTURES , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 15 No. 2 (2021): FUTA Journal of Engineering and Engineering Technology
- E. O. Ajaka, O. E. Abiodun, Determining The Metal Contents of Leach Liqour from Ihietutu Lead and Zinc Ore, Nigeria , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 14 No. 1 (2020): FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY
- Isa, I, Ajaka E.O, EFFECTIVENESS OF GRAVITY SEPARATION TECHNIQUES FOR THE BENEFICIATION OF DERU SILVER-GOLD ORE, BAUCHI STATE , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 17 No. 2 (2023): FUTA Journal of Engineering and Engineering Technology
- I. O. Adejumobi, REVIEW OF CONVOLUTIONAL NEURAL NETWORK MODEL FOR OBJECT DETECTION, LOCALIZATION AND CLASSIFICATION , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 20 No. Special (2026): FUTA JEET: Special Issue on Innovative Solutions for Sustainable Living and Environmental Challenges: Engineering Perspectives
- Jegede, B. M, Ojo, O. T, Akinnuli, B. O., EMPIRICAL MODEL AND SOFTWARE DEVELOPMENT FOR CRUDE OIL CARGO QUANTITY MEASUREMENT AND DISCREPANCIES DETERMINATION IN NIGERIA , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 16 No. 1 (2022): FUTA Journal of Engineering and Engineering Technology
- O OLANIRAN, J O BORODE, A E AFOLABI, P A OLUBAMBI, B A OLANIRAN, D O FOLORUNSO, CORROSION ASSESSMENT OF SINTER DUPLEX STAINLESS STEEL COMPOSITES IN PINEAPPLE JUICE EXTRACT , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 12 No. 1 (2018): FUTA Journal of Engineering and Engineering Technology
- Ugwu, S. J, Nwude, M. O, Shariff, F. U, ANALYSING THE IMPACT OF URBANISATION ON PHYSICO-CHEMICAL GROUNDWATER PARAMETER OF KADUNA METROPOLIS, USING STATISTICAL APPROACH AND BASIC DRINKING WATER STANDARD , FUTA JOURNAL OF ENGINEERING AND ENGINEERING TECHNOLOGY: Vol. 17 No. 1 (2023): FUTA Journal of Engineering and Engineering Technology
You may also start an advanced similarity search for this article.